Fronius TPS 320i and push pull gun!!

Fronius TPS 320i with push pull gun overview. Simple setup and function of how the unit works.

[@anthonydarby4674]

I use the split version for work. Oh man, what a badass machine.

[@tstrapper1]

Have you ever run the miller 350p with aluma pro push pull?..Im just curious how the Fronius is compared to the miller. thanks

[@Migman2020]

no offence but lincoln and miller are dog shit compared to fronius offerings. no one can touch fronius in the mig/mag area right now@@tstrapper1

[@bobansupergenije7512]

Fantasticna masina

[@Weldywelderfac3]

Struggling with the exact same set up for aluminum. It seems like I have to lay a bunch of beads for like 10 minutes before the machine starts welding correctly. It comes all black and nasty like it’s dirty but eventually works at cell phone. Is there something wrong with the machine? I’ve sent the machine back in they say it’s fine change wire didn’t change anything, the welder has been sitting for about nine months now and I’ve been using my Miller but I don’t want to let a $18,000 welder go to waste can you help me out?

[@kevinmickens9810]

Im trying to set up for aluminum welding on the TPS 320i but im definitely doing something wrong. Where can i go for a presets for aluminum setting.

[@Migman2020]

did you work it out in the end? or you still need help?

[@user-no5xu3jr4q]

Hello my friend, I have been looking for a good welding machine for a long time and I am between two machines 1 kemppi master mig 355G Water cooler 2 fronius TPS 320i pulse Water cooler. (The one you have) your opinion will help me a lot because you have already worked on the machine. Are you satisfied with the result of the machine? Thank you 🙏

[@eastech3365]

I can not speak for the kemppi 355g so that is not going to help you out much. I am very happy with this machine. The pulse options are incredible. It mainly stays loaded with aluminum and a push pull gun, but I have used it plenty with steel also and I don't have any complaints. I have an "up down" 15ft gun that I use for steel, and they can swap back and forth between my other fronius machines. (Push pull excluded, it only runs on the tpsi). Same drive wheels, same tips is just easy to run and always gets the job done. Good luck with your decision

[@user-no5xu3jr4q]

@@eastech3365 Thank you...