Front Bumper Cover Removal - Fusion / Mondeo (2013 - 2020)

This video shows how to remove the front bumper cover of a second generation Ford Fusion (2013 - 2020)

[@coolissimo69]

Dude great tutorial , 2:28 I was struggling so bad to take it out, didn't use an impact gun.

[@egscomp8074]

The best video on this thanks🙏🏾

[@TheNomadMechanic]

Thanks for your comments brother, regards

[@TerryBrown-kq8wl]

Great video. Thanks heaps!👌👋

[@TheNomadMechanic]

Thank you for your comments!!!

[@stanleyhenry3700]

Great Video, you make it look easy. I have a 2017 Fusion, based on your findings, it should be similar. I need to replace both bumper and fender. Some videos makes it look difficult. Some people remove the bracket that attaches the bumper and the fender. You only remove one screw and some clips on either side. Wow!! Do you have a fender removal video? You earn my vote.

[@TheNomadMechanic]

Thank you for your comments, unfortunately at the moment I don’t have one for the fender removal.

[@velvetpaws999]

Thank you so much, very helpful! I like that little electric screw driver that you use, as well as the red little wrench. Is that one specifically useful for any plastic plugs and such? Thanks again! Well done!

[@TheNomadMechanic]

Thanks for your comments and regarding your answer, yes, the plastic (red) is a generic plastic trim removal tool, very useful and cheap in my opinion. Regards.

[@alexpatience44]

what size is the bolt for the bumper to the wing please.

[@alanjm1234]

This is pretty easy. Try removing a Kuga/Escape bumper!

[@luisgabriellelualhati464]

How did u disconnect the block heater wire im having trouble

[@TheNomadMechanic]

I used a small flat screwdriver to release it, it is a bit tricky