G Series Feed Button Modes

[@bliblobliblob3279]

I used to use an Epson ET-2550 kzbin.infoUgkxciSwynMJ7PnUvvx11rewiu-yFBkZTl53 , an early model of the ink tank style. It worked well, but had one nuisance that drove me up the wall; if you didn't put it in high quality print mode you'd get a streak across the page. I'm happy to say I have yet to see this with this printer. The print quality has been fantastic so far, the set up was super easy. All in all I'm very happy with this printer.

[@eddiehidalgo7739]

How do you cancel printing jobs?

[@chessguru900]

My Zebra GK420 is flashing red slowly. The media is loaded and the lid is fully closed but still keep blinking red. I have tried to calibrate it but after calibration still goes back to flashing red. Any ideas?

[@sameershahid429]

same problem here ,4

[@farslayer68]

Thanks.. I had the 4 blinks for printer reset.. wasn't aware of the single afterwards to get the network settings cleared.. Couldn't figure out why the network setting sweren't being reset.

[@prospecstrings2043]

My GK420d flashes twice red and once green and won't print. Can you offer a solution?

[@NevsTechBits]

Thanks sir. This fixed my problem.

[@JacekPiechocki]

:) thanks a lot