G35/350Z Clutch Master Cylinder replacement| Garage Things Ep1

[@Turtlefarm]

Would air in my master prevent my slave from property engaging the transmission?

[@Grumpollo]

Excellent video! Only one I could find with the details I needed.

[@Tyquelle97]

What thread size fitting for the MC?

[@BS-nj8ve]

Struggling to remove the hydraulic line! Any suggestions?

[@paulinafornander-t2i]

so ur saying if i dont bench bleedit i now need to remove it abnd doit again

[@Tyquelle97]

Where could I get the adapter

[@Turtlefarm]

Right now I am having an issue I can’t figure out.. help? I bought a car with a new clutch. At the beginning. as I started letting out the petal from the floor, the clutch would grab hard. Didn’t have any issues other than a tick when I had the petal out and in N… When I’d press it in the noise went away.. the slave cylinder was bad so I replaced it and the master as well, bled them really well. And still had the tick and the petal would be slow to return all the way.. it would Pop back 60% of the way then slowly the rest of the way.. if you let your foot off the petal fast it basically comes up and then slaps the bottom of your foot.. now when I have clutch pressed in all the way I can’t get into 1st gear.. sometimes if i shift into 4th then try 1st it will work but it’s stiff.. once I get it into 1st gear I can come back to neutral and any other gear ( keep in mind car isn’t moving at all during all this. Just clutch in and manipulating the shifter.) but say i go back to neutral and let the clutch out all the way, then press it in again.. im back to square1 … can’t get into 1st gear.. stiff as a rock.. but I can sometimes get it into 4th and then 1st again after that.. any time I let the clutch out all the way in N I can’t get into 1st … side note when the cars not running I can go through all the gears .. clutch in and out doesn’t affect it.. only while running. Thanks for reading this ..

[@chuchupapi771]

I’m currently having the same issue. You find a way to fix it ?

[@Turtlefarm]

@@chuchupapi771 new clutch… it was my own fault.. I tried Greasing the pivot ball on the fork and ended up spraying grease on theflywheel so got a new clutch….

[@chuchupapi771]

@@Turtlefarm 😬😬 sorry to hear that man