G35 YAW Sensor Switch Tutorial | (Drift Switch)

Unleash your car full potential of your G35, G37, 350z and 370z! This MOD is so you can fully turn off traction control on the G/Z’s chassis. It will disable the VDC, slip light with the flip of a switch
In this video, I will show you step by step how to install a drift switch so you can have full control over your car! This mod is a must for drifting! So you can burn rubber as much as you want!
Like, Share, Subscribe!
Instagram: Mr.jfrancis_
Link to the switches: DaierTek ON Off Round Rocker... www.amazon.com...
#drifting #g35sedan #cars #drift #infiniti #350z #driftlife #370z #driftcar #nissan

[@Obi-2AQuanobi]

Ready to see that thing slide man !!!

[@Mr.jfrancis]

This weekend its going down!

[@jeflores1000]

Great video! I have a 05 Infiniti g35 and i just want to replace to Yaw sensor.Is there anything i should know or do before replacing it? Im selling the car and just want it to be safe to drive.My slip and Vdc is on and that's probably the only thing i didnt do as in replacing that sensor.Thann you!!

[@Mr.jfrancis]

Thanks and the steps should be the same except you may have some screws in different spots for the center console. Other than that you unhook the battery and make sure you do not screw the new sensor in with an impact drill

[@jeflores1000]

@@Mr.jfrancis Appreciate the feed back!✊

[@alvarezz7]

Hi. We are from Russia and tried to do the same on the g37s, it turns off the stabilization, but the ABS remains in working condition and because of this the car does not allow to do burnout. We need to come up with an additional solution... Maybe you have ways?

[@Mr.jfrancis]

@@alvarezz7 hey! And the for the ABS light you’ll have to splice the ABS wire under the glove compartment. I think it was pin 101 but I can fully remember. Or you can unplug the brake switch that is connected to the brake pedal that will allow you to do a burnout. BUT you will have no brake lights. So if you want to keep your brake lights you’ll have to do the ABS splice.

[@Domesticated96]

First!!!! RING THAT NOTI BELL SO YOU DONT MISS OUT!!!!!!

[@eduardosantoshernandez6669]

Do you need a welded diff to drift or burnout?

[@Mr.jfrancis]

It’s preferred to. I know some people that can drift an open diff. But it’s best to get a welded diff or to get your open diff welded or get a LSD diff. So you can properly do donuts and drift. And a welded/LSD diff is more predictable when drifting.

[@jefrymedina3067]

Hey I have a 2013 g37 rwd would it be the same process?

[@Mr.jfrancis]

Yes it should be. Your YAW sensor may have different color wire then mine and the center console comes out differently then mine. Instead of the 4 screws under the armrest vent it should be on the back side of the center console by the back vents.

[@dylancajo5347]

Is it the same process for a g37s manual

[@Mr.jfrancis]

It should be. It’s in the same spot.