G37 Sedan makes 670 Horse Power on Dyno!!

[@StrictlyNETER]

Now we just need a pov drive 🤔

[@By_Any_Means_Necessary]

Nice build i never seen a dyno in the junkyard that was different but still a cool build 👍🏾

[@infinitibossauto]

How in the world did your rods survive over 500 torque on stock

[@EddySpaghetty]

What's the most they reliably hold? 400?

[@infinitibossauto]

@@EddySpaghetty yes 450 under 500

[@MiguelRodriguez-gw8kx]

I fucking love the sound of it

[@Osamabeenleanin210]

Hellcat owners bout to be sick😮‍💨😆

[@00j80]

this is a boss level car literally the rev sounds intimidating and scary to anyone about to race you

[@RyanMorgan32]

You can fit the front grill back on after you install turbo?

[@sikhg37]

Clean build.

[@JesusMendez-mg7ld]

perfect build

[@MessiahTheAnomaly]

Did you rebuild the engine before you put the turbo on?

[@CRTFD_G]

No it’s a stock motor

[@slowvhr]

@@CRTFD_Gg37 sedan or this a coupe g35?

[@CRTFD_G]

@@slowvhr title says G37 sedan brother

[@slowvhr]

@@CRTFD_G I know I just seen people asking obviously question wanted to piss you off😂

[@Mike-yp7sd]

Yes sir 🔥🔥🔥🔥🔥

[@abbas674]

Holy fuu stock motor how many miles have you replaced water pump galley gaskets before turbo kit

[@CRTFD_G]

I blew the stock 2011 motor from turbo almost 3 years ago. I put a stock 30k mile 2017 3.7 engine in it and it has been good ever since. Never done water pump or gaskets on any engines before

[@v36vhr]

​@CRTFD_G you have fuel return kit?

[@CRTFD_G]

@@v36vhr yes CJM S1.E

[@tybo_g37s]

Strong!!!!

[@anthonyrodriguez7842]

How much boost was needed to make the 670whp? Curious to see how effecient these turbos are.

[@CRTFD_G]

15 pounds

[@anthonyrodriguez7842]

Nice. That gives me hope to see 850whp at higher psi

[@T4nku0ut]

all in all- how much did this turbo kit/tune/labor cost? i.e. how deep are you in? Considering going this route...

[@CRTFD_G]

I bought my kit used for $4,500. I do my own labor, tune will be $800-1500 depending what route you go.

[@T4nku0ut]

@@CRTFD_G thanks for the inspiration =]

[@keziahgibbons]

Idk why I thought you were like 800 to the wheel 🛞 already lol

[@CRTFD_G]

That’s too much power for stock motor.

[@BlazeVonWolfsburg]

Why did you go back to stock manifold vs the soho one

[@CRTFD_G]

I’ve never had a soho one.

[@tre2216]

hey, do art pipes actually give more gains compared to berk test pipes? ive seen another youtuber say this.

[@CRTFD_G]

All test pipes gonna give you same gains

[@nevergiveup2365]

Where u get those seats from? 🔥🔥

[@CRTFD_G]

Juke Nismo RS

[@nevergiveup2365]

@CRTFD_G Those fit the Gs ? Bolt on?

[@CRTFD_G]

Yes & no. It’s a little complex of swap but doable. Check out my KZbin video on it

[@nevergiveup2365]

@@CRTFD_G copy

[@Slvdr_pz]

Where is this at ?

[@CRTFD_G]

Infiniti Motorsports AZ

[@DarrylCook-o5p]

No upgraded fuel pump ?

[@CRTFD_G]

Walbro 525 pump

[@gavino4.835]

How did you remove the rear camber?

[@CRTFD_G]

Camber arms

[@gavino4.835]

@@CRTFD_G what brand did you go with ? And is that all you used ?

[@eugene.p04]

what kit is it?

[@CRTFD_G]

Gonzevo Top Mount

[@kiingvq]

red interior i love ut

[@infinitibossauto]

What size turbo?

[@CRTFD_G]

All mods in description bro. Comp 6871

[@infinitibossauto]

Wait did i read u made 670whp on stock unopened motor?​@CRTFD_G

[@CRTFD_G]

Did you watch the video bro? Lol

[@infinitibossauto]

​@@CRTFD_Gtooo shocked

[@prvideos8229]

Not bad the G37 would smoke my stockish Kia from a roll and maybe in the 1/4 but my Nissan will smoke the G37. That place looks like a junk yard for infinity 😂😂😂😂.