Productivity 1000 Series PLC - Documenting the Program

[@ACCautomation]

Productivity Suite Programming Software v3.3.0.17 has been released. support.automationdirect.com/products/p3000.html Regards, Garry

[@ACCautomation]

All automation direct software can be found at the following URL: www.automationdirect.com/support/software-downloads Regards, Garry

[@ericromero9618]

I have a lot of experience with AB PLCs, but not automation direct. To do a simple program like one shot to a add instruction and one shot to a sub instruction. For example: ons B13.1 sub N7.1 1 n7.2 Ons B13.2 add N7.3 1 N7.2 GEQ N7.2 0 OTE B13.3 I made this up on the spot for ab. You’ll copy it into the ascii bar and it will pop up. I don’t know how to do that in automation direct.

[@ACCautomation]

Hi Eric, The productivity series of controllers will use an edge contact. This is the same as the AB one-shot. accautomation.ca/productivity-1000-series-plc-contact-and-coil-instructions/ This post will discuss these contacts. All math instructions are done using the Math Instruction in the productivity. accautomation.ca/productivity-1000-series-plc-math-instructions/ Here is the entire series for productivity. accautomation.ca/series/productivity-1000-plc/ I hope this helps you out. Regards, Garry