GD&T in MCOSMOS, Mitutoyo

Flatness, Perpendicularity, Parallelism

[@harshpatel6419]

Your videos are helpful. I have recently got a job as a qa tech and the company uses mitutoyo cmm. These videos have been really helpful. thank you

[@monkeyskit69]

Where are you located? I can provide more training for you. I work for mitutoyo

[@DanielDias-eh5pi]

Obrigado pelo vídeo, Parabens!

[@luisdanielcuevas5672]

i watched the video with interest in the software, thank you for that. now, with all do respect, that is not GD&T; to comply with the norm you need to put a lot more points in each plane so you can capture the entire surface, 4 points won't do.

[@ZakisHereNow]

Have you ever programmed without the manual inputs? If so, do you find manual easier? If so if so, is it easier enough to justify the cost? Right now I’m just programming and using offline mode and CAT1000 to prove it out.

[@3073Sean]

Thank you for this !

[@RAHULDAS-cr5fl]

After very long time

[@frivolousmusician5849]

great content!

[@mavh6139]

Just ask if theres effect on measuremnt accuracy if the TP20 Module need to replace? Always error Collision,cannot retract good.tnx

[@RAHULDAS-cr5fl]

How to scan any parts with dimension with memory recall options

[@RAHULDAS-cr5fl]

I am so happy

[@alinaobrien1399]

hi Todd.. could you please confirm. Profile callout can be measured only in CAT 1000PS Programming? when CAD model is loaded, right?

[@machinisttodd]

I still haven’t figured all of CAD model driving and operating out yet. I’m afraid to say yes or no. Hopefully someone smarter than me can get the correct answer and post it here.

[@RAHULDAS-cr5fl]

Please help in profile scanning

[@alinaobrien1399]

if anyone knows. please comment. how to measure position of two slots with MMC ON CYLINDRICAL PART. DRF A(plane) and B(od axes) (no clocking datum)....programming from part(no cad model)... thanks:)))

[@machinisttodd]

Can anyone help with this? I’d like to know myself. I think y’all viewers have about reached the end of my knowledge. Now it’s time to help each other out with more learning. Me included!