Gehl 41 hammer mill

Using a gehl 41 hammer mill to grind ear corn for my beef cows

[@30acreshop_time]

1:12 that was a crusher attachment which was quite rare as well as that auger for loading wagons or putting it into a bin. Gehl had that attachment so that you could steadily flow corn into the mill and not have to slowly rake it in, so if your drag line belt was good you could’ve just let the corn flow. Looking forward to more hammer mill videos hopefully in the future!

[@backachershomestead]

We had a Knoedler hammer mill. Wish I still had it. That's a nice setup you have 👍👍

[@danw6014]

We had an old Case hammermill bolted to the barn floor that ran off the belt pulley. We put ear corn on a flat rack so you just shoveled it in the mill. The pipe was set to blow the corn into a bin in the barns granary. The cows were down below the granary so we filled a feed cart by gravity for the cows. You may keep your eyes open for a good grinder mixer. I grind feed every weekend. It's much easier, and yes I still feed ear corn.

[@charlietanner6211]

very interesting you need a idler pulley to keep ntension on that loose belt good piece of yesterdays techinoligy

[@KevinChristiansen-i2q]

Nice looking hammer mill

[@hturbo1007]

Whenever you have a worn belt that slips like that, just go to the house and get some maple syrup and dab some on the working part of the belt. It'll get you by until you can purchase a new one.

[@LVFFarmVlogs]

If I remember right, you loosen up the 4 bolts where the motor mounts sit on the elevator then slide it down to tighten that belt

[@railroadguy8080]

Hammermill videos are always appreciated! It appears to be doing an excellent job. Affirm Ephesians 4:2.