www.generalpartitions.com This video shows the installation on a Series 40-5 Baked Enamel Toilet Partition from start to finish.
Пікірлер: 13
@vikinglaminates15328 жыл бұрын
great job learn few things from these video
@princeianquilbio89783 жыл бұрын
Hello, may I know what materials do you use for the fabrication of the panel?
@captainzuesss16853 жыл бұрын
How did you go from installing U brackets to installing headrail....SMH
@generalpartitions12 жыл бұрын
For a baked enamel toilet partition from start to finish it should take approximately 1 hour.
@vankhanh1006888 жыл бұрын
good video. can i use your video in my website? i will take note that this video from General partitions.
@Tradesmanservices12 жыл бұрын
Good video. About how long does an install like that take?
@rinzler2246 жыл бұрын
Jack TradesmanServices to long
@danielochovska67184 жыл бұрын
8 hours
@mikebitterman959911 жыл бұрын
not bad video but looks like you put the panel higher then the door. they would kill me if i did this on my job. also jack tradesmanservices its hard to tell how long it should take because of conditions of job? people in ur way trying to get work done? lights in the bathroom on or not? the manufacture make the right crap and give u all this crap u need. this video shows a perfect world installation. conditions are never this good in real life
@jinobeano73033 жыл бұрын
how do I take appart strall
@tylerfritz802 жыл бұрын
Use screw gun with security bits
@Jstuckey9 жыл бұрын
This guy has got to be the slowest installer ever lol, and sharpie marks on the floor?!? So I take it that you guys back east installing these things are hourly and not piece rate right? The dude's not even wearing tool bags, so has to walk somewhere to grab a screw? So yea any metal partition should take about an hour to install, but that's including rolling out your tools, pulling in material, installing, cleaning thoroughly, rolling up tools......one guy, no help.
@k5Motorsports9 ай бұрын
Are you saying you can install those partitions in 1 hour including setup time? I’m not giving you a hard time but I’m looking to get into Division 10 products and need some feed back. Thanks, tools etc