Mastercam multiaxis - Impeller test cut on a rotary table

For this test cut, the part was rough milled with 3D roughing toolpaths using indexing method. The blade and floor are finished with "basic" multiaxis toolpaths (Blade Expert option is not available)
Machine Mectron MTV-T451
CNC Controler: Fanuc 21i-MB
Inversed time feedrate: No
Dynamic work offset: No
Tilted work plane: No
RTCP: No
Part material: Epoxy tooling board
The following toolpaths was used:
2D Dynamic Mill: 00:10
3D Area Rest Roughing: 00:28
3D Horizontal Finishing: 00:51
Multiaxis Morph between curves - 4 axis output: 1:00
3D Area Rest Roughing on tilted tool plane: 1:18
3D Pencil Finishing on tilted tool plane: 1:57
Multiaxis Swaft Milling: 2:29
Multiaxis Morph between curves - 5 axis output: 3:12

[@DuyLe-qe6fu]

đỉnh quá anh ơi

[@farhanchoudhre6962]

very nice. which software you use for post processor output

[@GIANGTHETOOL]

it's a modified generic fanuc 5X post