Radio Lipo Mod - XK X450 Aviator 2.4GHz 6G/3D RC Airplane‎ Drone RTF

[@kanarimentos7056]

if you have problem breaking props you can use WLtoys XK X251 props work fine maybe little stronger

[@GIJOGadgets]

great. thanks for sharing.

[@bodeksrc8007]

Just bought them👍 we will see👍they look bit stronger, but I dont think that one on the back can be replaced as these black ones from x251 looks bit bigger and may not fit that hole, but at least front should be fine

[@bodeksrc8007]

Is that antenna solder into the board or uses ufl connector? Im about to do 4W 2.4ghz booster mod on this radio to fly my x450 fpv and not worry about range

[@GIJOGadgets]

Wow wonderful.

[@howarddkeney3986]

I watched GIJO's radio mod. The radio case calls for 6 x 1.5v batteries = 9 volts. I could not tell if the radio battery mod was a 2s Lipo, but it looked like it. 2s Lipo nominal volts =7.4 volts. 7.4 volts is 1.6 volts or 17.8% lower voltage than what the radio case call for. So, my question is, 1) will the radio work on a 2s Lipo and 2) will the radio still have the same or sufficient range of the 9 Volt battery setup?

[@GIJOGadgets]

Hi. Yes.. I use 2s lipo for the modification. It works well. The only worried is that, lipo 7.4v full charge at 8.4v dropped to lowest at 7.4v after 3 times flying. Better not to continue to fly when lipo only hav 7.8v n below as the tx will cut off at bout 7.1v.

[@fastfrank61]

www.amazon.es/2200mAh-bater%C3%ADa-transmisor-Battery-Transmitter/dp/B00QKYKL6S

[@howardkeney6492]

is this a 2s Liop battery replacement?

[@GIJOGadgets]

Not a replacement, it just another way to power up the tx using rechargeble lipo.

[@fastfrank61]

Hello from Spain youn have 6X 1,5V Alcaline so you need 12, V and i insall it in the case and put out the plastic and buyed in Amazon a Lipo for 11.1V 2200mAh batería Lipo para RC transmisor C305 // 11.1V 2200mAh Lipo Battery For RC Transmitter C305 in Amazon for 12,90 Euros and its inside of the transmitter !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!www.amazon.es/2200mAh-bater%C3%ADa-transmisor-Battery-Transmitter/dp/B00QKYKL6S

[@Bombana01]

@@fastfrank61 6x 1.5V = 9V

[@chorianopoulos2002]

Is this a 2S battery? And do you know if a 3S would damage the transmitter?

[@GIJOGadgets]

hi. yes, 2S battery. Not very sure on 3S battery but better don't take the risk.

[@drone_adv46]

@@GIJOGadgets will it be okay if we use 2S with 2200 mah instead

[@Molotov_TH]

Do you know how to change mode 1 to mode 2? I can't find it in the manual.

[@GIJOGadgets]

You can try just swap the stick gimbal vice versa

[@theoztreecrasher2647]

Press and hold "Stick Mode" button then turn on transmitter. Then adjust centering springs and drag plate screws under rubber bungs on back of transmitter. By swapping stick gimbals you can get mode 3 & 4.

[@GIJOGadgets]

Premiere Tonight 25 May 2020 at 9pm #stayathome #stopcovid19 #mcoproject Check out my latest video "What Will Happen? XK X450 Aviator RC Airplane‎ To Tricopter Mod" #gijogadgetscollection #4kwatchhour #2ksubscribers #challenge #kotakinabalucity #sabahmalaysia Watch Now: kzbin.info/www/bejne/rV6mkKeOar6BiNE

[@freddy86fm]

Sampin ko bossku.... Camera canon ko pandai kah ksh bagus,ada camera sya jemm bah... Salam dari KZbinR BAH NI

[@GIJOGadgets]

Hi geng. Camera indak pandai pula saya. Belum kena training lagi. Hehe

[@chorianopoulos2002]

I made the same mod. Also powering a booster with same battery. I’m using an 800mah battery and it’s easily powering both.

[@GIJOGadgets]

Wow, that's a great idea. Thanks for the tips too. How was it? have you fly it yet?

[@chorianopoulos2002]

kzbin.info/www/bejne/jJ-7e6eiqceKn9k

[@stevemann6082]

all we need now is to add rssi meter.

[@VincentFischer]

not happening

[@chorianopoulos2002]

Here is my setup: kzbin.info/www/bejne/jJ-7e6eiqceKn9k

[@GIJOGadgets]

Nice. Thanks for sharing.