Gktech Z34 370Z Front Upper Camber Arms - Install

[@FrankTheKoyFish]

Have yet to get a Nissan but these videos always get me

[@Silverbulletdc5]

So to do the adjustment once installed. The wheels have to come off?

[@gktech]

Correct

[@Brian-cb3ce]

So halfway point is -2.5. I guess no need to go to alignment shop after installation?

[@kmc4747]

So when adjusting after installed does the Allen key extend both parts of the fuca or only 1 part. Then you have to adjust the larger piece by taking it out the car.

[@gktech]

It adjusts the extender evenly, no need to remove the arm.

[@kmc4747]

@@gktech ha ok wonderful I received it yesterday. Hoping to do the install soon

[@robertsoneliassaint4565]

how much negative camber would it give me if maxed out ? plus i’m lowered

[@gktech]

Our tests got to around -5 before maxing out, after that an extended lower arm is needed.

[@carlosruelas6854]

the jay arms already came installed in the FUCA's. Do I have to uninstall them and add Loctite or are they good to go?

[@gktech]

You will need to uninstall and add loctite

[@lion3014]

Literally just got mine in the mail about to go nuts on em

[@outdehmovements6273]

Can this fit a q50

[@gktech]

We can’t confirm, sorry.

[@outdehmovements6273]

@@gktech I’ll let u knw how it goes am sure am not the first I’ve check the forms

[@lion3014]

I think the g n q use the exact same front suspension components apart from maybe inner n outer tie rods, check the part number on the oem arms to see if they are the same for the G Q chassis

[@outdehmovements6273]

@@lion3014 it’s been 3 months solid but had to raise the car a lil because of clearance so jus remember to check for clearance and watch the installation video the guy was on point with everything 💯 car is a 2018 q50 3.0t luxe rwd

[@fahadazad3263]

@@outdehmovements6273have you experienced any rubbing?

[@teckniec2]

This video was entertaining. I haven't heard of your company before but these look awesome. Just ordered them.

[@filip000]

This video is just awesome

[@mog7501]

Can we put anti-seize on the threading or is that dangerous/not recommended for this material? I don't wanna have to deal with a seized camber arm when I have this maxed out negative camber for summer drift sessions and then when I want it at OEM spec in the dead of winter it's all frozen 😂😂

[@Malficion]

Right... Scientific ugaduga and voodoo laser lift. Not happening, Sr! I got them 1ft wrench, my 55lb/35lb rocks, and strings from my last alignment!

[@Martin911]

Can y’all show me how to last longer in bed using home tools 😂😂