Setting up Pinion Depth and Backlash on a 7.5” rear axle using .the factory GM Kent Moore tools
Пікірлер: 16
@Guyver500053 жыл бұрын
pinion shim should equal 0.047 thou gauge went counter clockwise. time 4:07
@enriquemartinez163 жыл бұрын
Exceptional
@JacqlynCharles2 жыл бұрын
Thanks for the Great hands on lesson. Pick up the same set at garage sale but missing parts and instructions is it possible to get a photo of the instruction sheet can not find online. Thanks
@obbyjep75973 жыл бұрын
When a guy is changing parts wit the diff in the car is it nessasary to use a spreader or can you just get it so it will go together?
@adamcorbett50693 жыл бұрын
Will this kit work on a gm 7.2 ifs front diff ? Also would you share the installation instructions from that kit with me for specs ? I am purchasing that kit used and it doesn’t have any of the installation sheets
@merliclovis4 жыл бұрын
Thanks for the lesson! I currently have an 06 chevy1500. When i get off the throttle I can feel a slight grind feeling. It was worse before I replaced universal joint but still there. Any idea where i should look?
@LakelandAutoMarine4 жыл бұрын
2wd or 4wd? Could be pinion bearings.
@harrisjr98493 жыл бұрын
What so you charge for 10bolt
@rodneyfama6399 Жыл бұрын
What is the kit number for the 77 gm 8.5 10 bolt. And 68 olds 12 bolt
@HeathersHusband8387 Жыл бұрын
What size black impact socket did you use for the pinion shaft nut ????
@eliashg2050 Жыл бұрын
32mm or 1.25"
@DELTRANIO993 жыл бұрын
Great vid my 10 bolt makes a loud noise when accelerating ,,,Coasting and letting off the throttle its quiet
@jondough41163 ай бұрын
Needs to be reshimmed a couple thousands usually on left side ring gear side worked for me..
@codyeberhart88073 жыл бұрын
What is the part number for the pinion bearing
@jimsperlakis56342 жыл бұрын
Your Fowler dial gage is as cheap as they get. Don't matter the way you're going at it will probably only be able to get it within .002 anyway !
@hillarylevenworth88242 жыл бұрын
A blind man might like that pattern but you could have made it much better than that!