If it wasn’t for you older guys us younger guys wouldn’t know shit.thanks this really helped
@elitebuildingsolutionllc8736 Жыл бұрын
Great video. I'm digging into my tbi for almost a year. This week will get into the gas tank. Thank you
@MojarraMutante3 ай бұрын
Man…. This is EXACTLY what happened to mine. I would not have checked it if it was not for this vid. Many thanks, back on the road!
@sergiocespedes99311 ай бұрын
Thanks a lot. I think you just saved from going out of my mind and burn my truck. I have noticed that loosen clamp in the hose, and never thought it was needed.
@jimhenderson9199Ай бұрын
The technical way to describe that situation that occurred on your truck is to say operation of the system that supplies the fuel is flow limited. Its supposed to be pressure limited as dependent on the fuel pressure regulator which is basically a relief valve that is open during normal operation. What I learned from your video is that I can rent a gauge to check my fuel pressure. Hope it's the regulator stuck open if I have low fuel pressure. At first the fuel pump wouldn't turn on but after fixing the ground connection my truck still won't run unless I pour gas down the inlet
@dale3990Ай бұрын
Sounds good , been having the exact same issue with my 94 Chevy Suburban k2500, will check that out...cool background music.
@thomasneemann561826 күн бұрын
thank you very much
@brianbvachek32193 ай бұрын
Ha! I bet this is why my ol ladies truck takes about 10 seconds to start, and mine with a fresh pump/sender/tank fires off in less than one good ol Mississippi second… Thanks brother!
@johndunn678 Жыл бұрын
A cheap easy upgrade for these is to install the pump for 1996-98 Silverado with the 5.7l Vortex v8. It flows more, is better able to hold the factory pressure, and is pretty much plug and play.
@williemelton75442 ай бұрын
Hey thanks this is a life saver 🎉😊
@philtolfreeart Жыл бұрын
Thanks for the video. Just came here to say, you sound exactly like the sheriff of nottingham from Disney Robin Hood 😂
@markstewart81717 ай бұрын
Man, I had the same exact rubber hose split on me. I dropped another one in and was looking at the old one not figuring out how it was broke until I saw the split the next day. I fortunately replaced the whole thing all together, don’t like buying off junk cars for sensors and no sense in putting old parts back in the fuel tank as it was a bitch to drop the tank and all. Glad to see others finding a 30 year old hose goes bad the same way. Best of luck to ya. Also don’t put a rubber base down under the tbi , figured that out the hard way after paying over 300 dollars for all the sensors connected to it around the tbi. That rubber base and gasket is a joke. Just use the gasket straight to metal.
@paulferrara90799 күн бұрын
Thank you !! : )
@LordPente9 ай бұрын
Well, I guess I'll check there, too. Thanks for the Vid.
@mcqueenfanman9 ай бұрын
Another way of confirming bleed down issues is do a pinch off test. Put a gauge where the fuel filter goes and pinch it off right after it. Prime the system and it should hold up to 18psi of pressure. If not its bleeding down somewhere, if you don't see or smell gas then its inside the tank.
@louf717811 ай бұрын
Thanks!
@shawnhector79313 ай бұрын
Thanks
@robertfisch4603 Жыл бұрын
I didn't hear him say he replaced the gas filter. That's what was causing low pressure on mine.
@CraigB-rw9cu4 ай бұрын
Well i got an 1989 put new distributor fule pump.fule sensor and fues new air flow sensor new coil cleaned grounds anf as i got down the road not even a mile it dies wont start back and ill go to the battery and just losein the hot and turn key on go back to battery and move the hot i can hear the pump but no squrt to the injetors untill i shake the hot cable it wont do it all t
@clintdearman25089 күн бұрын
Or.... just replace the entire assembly and not just the pump itself.
@jf4872 Жыл бұрын
Another thing that will confirm for one if this issue exists...fill fuel tank full. Does the issue go away? I bet it does until the fuel level drops below the split line.
@agele55 Жыл бұрын
Sorry…but no. As long as the pressure is higher in the line than in the tank, it will simply back feed the tank. Trust me.. I tried that too.