Golffe Plays Square Launch Monitor with the latest Update

[@LlewelynJames-l8s]

Hi there, I have an idea for you to test...how far does the dotted ball go without dots? Your ProV1 goes far, but is that only because of no spin?...Your dotted ball goes nowhere but is that only because it spins too high? What happens if you tipex the saint nine dots away. How far does that ball go I'd love to know?

[@golffe]

I'd say the Saint Nine balls are quality balls too, I suppose if I used a top Flite, Srixon or wilson as a basic ball they might be less distance, I will try them today.

[@nickneale2237]

Noticed that AoA and D.loft still aren't reading. Was hoping this would be fixed in the update.

[@randcrnk]

It's been listed that it will read the other club metrics when you change clubs, some reason it does not when the driver is selected

[@golffe]

@@randcrnk didn’t know that, I’ll take a look tomorrow and try it.

[@MetalGear69]

So what's the deal? It's reading too much spin on the longer clubs?

[@tomgee632]

I think (could be wrong :) )the very low spins (estimated spin that for some reason as pointed out by another KZbinr is very low after the previous update) are when Golffe is using the club sticker with an undotted ball. The higher spins are true readings as seen by the Square with the dotted ball.

[@golffe]

@@tomgee632 I use the dotted balls on clubs from lob wedge to pitching wedge for spin, then as I hit a naturally high ball I use undotted balls, the spin is lower than normal but the distance is closer to my distance IRL, if I use the option +5 I use dotted balls all the time. I think if you could get prov1s with dots on this would be closer to my distances. Over all it’s only 3% off the distance using the normal ball option on the squares software.