Omron MX2 VFD local control, Auto tune, Commissioning, Factory reset and Parameter set up. (English)

[@mindaugass]

My MX2 can't run or run auto tuning after reset :( RUN key is active).

[@jajangbahri875]

I want to ask.i havr inverter omron 3g3mx2.i have error e30.1.how to solution?how to reset

[@psanoop2010]

How to rectify your E30 drive error issue

[@adrianalexandru5398]

Hi, i have a problem with my inverter, when I reach speed of 13.75 the motors stops completely

[@hemalpatel4462]

How can I remove error code E14.1 from omron sysdrive 3g3mx2 inverter?

[@obbpunya3918]

fixed ??

[@PetunjukJaLan-r1y]

Good job brother 👍 🤲

[@IGSElectronics]

Thanks ✌

[@sufrihadi]

Hi, can you help to show how F004 funtions please?

[@MrRogerpettersson]

Hey, great video, I just got my hands on a couple of these inverters and I just hooked one up folowing your instructions, it a 3 phase but the programing part is the same,, but I have a question as soon as i lower the rapm to really slow or even hit run, my motor makes some bad knocking sounds as the rpms goes down, have I missed somthing inte config you think?

[@IGSElectronics]

Hi there. How low are you going and what is the motor doing work wise, I.e what is its loud

[@MrRogerpettersson]

@@IGSElectronics The knocking sounds comes when i try to zero the rotations i.e slowing it down, or when it starts from zero, it knocks up to a certain speed the it runs smooth. I have since shifted to another motor which is a bit more powerful and on this one I don't have this issue, it speds up and down perfectly, but I can't get it go in reverse instead :)

[@MrRogerpettersson]

@@IGSElectronics kzbin.info/www/bejne/sKaYhICslL6betk

[@MrRogerpettersson]

@@IGSElectronics kzbin.info/www/bejne/oqSsmJKqpZt3oa8

[@IGSElectronics]

@@MrRogerpettersson Is that sound comming from the drive or motor, if it is motor, then i doubt wary much that that is anything to do with your drive. There is something happening with the motor or gearbox that, that happens on low frequancu. If you have a other motor to test on, would be good idea to check it out.

[@dennisrubio2375]

Sr the parameter for rpm plz help me

[@engineer_nyasha]

thanks

[@IGSElectronics]

Welcome