Halloween coffin/ animated

This is an animated coffin i made for my cemetery display. Made from 3/4 foam wall board. Lifting rig is done with flat stock metal and a 12v gear 5rpm motor.

[@BanthaPooDoo64]

I put on haunted house shows from 94 to 2017 free for trick r treaters to enjoy in my better yrs and this is so awesome great share thanks.

[@bluedakota80]

@BanthaPooDoo64 thank you. We have been doing it off and on since 1984. My mom started it. It's been a family thing all these years. And the same thing we do it free for the kids and families.

[@blakimus13]

Excellent job! Thanks for the inspiration!

[@tinadusablon7105]

Another amazing prop!

[@bluedakota80]

Thank you

[@grandma_boo]

Fantastic prop! That's something I never in a million years could have done. May I say one thing, though? It's the cross. It's in one piece as the lid is lifting. Shouldn't the bottom part of it still be on the coffin when the lid lifts?

[@bluedakota80]

Thank you, I figured that if it was nailed, it probably only had one or two nails in it and those would have been near the top. So the bottom half wouldn't have been attached at the very bottom, allowing it to move with the lid.