Hammer N4400 Extension Table Installation

[@stevecollins9450]

That is one fine set up there, Sean.

[@simplecoveoffcuts3672]

Thanks Steve!

[@dr.christianrapp]

A pity Sean you still have no video discussing how you use the saw and how satisfied you are with it. Cheers Christian

[@dr.christianrapp]

Would be great to see a video of how the bandsaw actually performs in your opinion! Best Christian

[@jaykepley5238]

Nice job. Beautiful bandsaw! 🖖

[@simplecoveoffcuts3672]

Thanks Jay! I'm fortunate to have it that's for sure.

[@jaykepley5238]

@@simplecoveoffcuts3672 I hope I have the same feeling soon! I'd enjoy that bandsaw.

[@IEnjoyCreatingVideos]

Great job Sean! Thank you for sharing the video with us!💖👍👌😎JP

[@simplecoveoffcuts3672]

Thanks 👍

[@IEnjoyCreatingVideos]

Your very welcome Sean! Have a wonderful week!😎

[@johnp1839]

Great review. What is the height of the table from the floor? After more use any additional thoughts on this saw? I'm considering this model over the Powermatic pm-1500.

[@rickyhernandez7193]

Hi, where did you purchased the table extension from? Can you provide a link? Thanks

[@biedawo]

thanks for sharing. I see it getting some use in your instagram. As your tools have settled in, when are you using this relative to your tablesaw?

[@christophedelepaut6398]

👍👍🇧🇪

[@gregcwoodward]

For an over $4K bandsaw (w/ a few attachments like this extension table) this is a pathetic design. Hey Hammer/Felder - how about two collared/tabbed washers and adjustment screws to EASILY adjust/level prior to tightening? The instructions that come with the bandsaw (much like a bandsaw blade) are non-existent. Thanks for the videos, though, you are making up for what is lacking in the product design and instructions.