Hazardous Locations - Zone 1

Electrical equipment is often installed in locations where there are gases present, making them hazardous locations. Therefore, these products need to be designed and constructed in compliance with safety standards in order to be safe for use in such hazardous locations.
As per International Electrotechnical Commission standards, the classified areas are categorized in three groups: Zone 0, Zone 1 and Zone 2.
This diagram of a typical petrol station illustrates the areas that are classified as Zone 0, Zone 1 and Zone 2. In this animation, our focus is on the Zone 1 classified area.
Zone 1 is a location in which explosive gas atmospheres are likely to occur in normal operation; or the location is adjacent to a Zone 0 location, from which explosive gas atmospheres could be communicated.
In this illustration, we have a storage tank which contains a flammable liquid. When the flammable liquid is being transferred, the area around the vent of the tank is Zone 1. Explosive gases can be present under normal operation or if a fault happens.
In order to be certified as compliant with safety Standards for Zone 1, the product must be protected by one or more of the following nine protection techniques: intrinsic safety, encapsulation, flameproof, purging and pressurization, oil immersion, powder filling, Increased safety, optical radiation, and special protection. Equipment compliant with these protection techniques are considered to be safe under normal and even abnormal conditions.
It is important to use the protection technique that is best suited to the product based on its design and function. Products suitable for use in Zone 0 may also be installed and used in Zone 1.
Please see our other videos to learn more about other classified areas, as well as the protection techniques that are specific to them.
If you are a product designer, or a buyer, and need an electrical device that has been certified for zone 1, the Hazloc Directory website can help!
Hazloc Directory is the world's most trusted source of information about hazardous location products & manufacturers.
HAZLOC DIRECTORY
www.hazlocdirectory.com
Background Music: www.bensound.com

[@mohamedguedmani1443]

if motor require 35mm square cable being installed in Zone 2 . if wd install this motor in Zone 1 , Do we need to increase cabl size or no? cable size not affected by zone classification?

[@hazlocdirectory6897]

Hi, the motor cable size is not related to which classified area the product is installed. However, the type of cables need to be appropriate as per zone hazardous areas. If you install your cable in Zone 1, it needs to have proper protection technique (Flameproof, increased safety, purging, etc.) and the cable needs to be selected correctly.

[@mohamedguedmani1443]

@@hazlocdirectory6897 thank you