HELLER CBC 200: CylinderBoreCoating of an I4 Cylinder Block

More: www.heller.biz/en
HELLER developed the CylinderBoreCoating process for coating cylinder bearing surfaces of passenger car engines for series production.

[@avionicstechshop7664]

This is cutting edge technology. Additive machining process. Can't see how this could get a thumbs down. Thanks for sharing. 👍

[@Baard2000]

Thumbs down from sleeve manufacturers........

[@avionicstechshop7664]

Greetings @@Baard2000: I'm hearing this is the new thing. I've seen demos of this CBC in action. It looks like a top notch process. While everyone is certainly entitled to their opinion, curiosity pokes at me to ask you why you feel negatively towards the technology? Have you experienced something that buyers should beware or is your statement just your bias?

[@Baard2000]

@@avionicstechshop7664 I was just being very sarcastic....... I could imagine sleeve manufacturers would not like such a technique. But , to my knowledge now, applied in the right engine , mostly light petrol engines , it is of double benefit : cheaper to produce and less fuel consumption because of better sealing and lower friction. And also pretty long service life. If worn out.....the only 2 options are open : recoating , company in UK does that. Or put a sleeve in..... For diesel engines the coating bonds not good enough to prevent flaking off due to higher cylinder pressures and much heavier parts....... In some racing classes these type of coating is used to lower friction and increase bore an piston life ( keeping hp as high as possible during whole engine life)

[@bdkw1]

Neat!

[@paulsmith-ld8xl]

Sweet

[@mohamedfarid7499]

niles simmons or WFL or sttarag or danobat ?

[@joemar1950]

where this shop located?

[@HELLERMachineTools]

HELLER is headquartered in Nürtingen, Germany. We have 5 production sites in Germany, England, Brazil, the USA and China as well as more than 30 local sales and service offices directly in the markets. Learn more: www.heller.biz 👍

[@joemar1950]

​@@HELLERMachineToolsthanks for the info..Im from Malaysia and I would like to send my car cylinder block to any country have this machine