Hi-Capa Nozzle clean up, fix for bb Jam, Cycle delay, slide delay

[@tough101]

Nice hearing an airsoft KZbinr with praise and worship music in the background. Great vid!!!

[@e-tactix-airsofttrooper7491]

Thanks Bro :D

[@tylerfriend1473]

So my nozzle isn’t sliding freely is it the O-ring swelling?

[@e-tactix-airsofttrooper7491]

it be difficult to say from text only. but i would suggest cleaning 1st. then if it persist. do elimination method. remove inner and outer barrel assembly and recoil spring. manually slide asee if theres restriction. [you also mentioned "isnt sliding freely" so im assuming it slides. just restricted... [different from, getting stuck and not compeleting a full cycle?] last time i saw this issue. it was from a oring plunger like u said. his o ring. was rolling over inside the loading nozzle. it was only noticed when the loading nozzle went full jam. ]

[@chickennugget30482]

it helped

[@papat4122]

Boss. What would be the problem if my hi capa is keep on slide locking when firing even there is load of bb? Thanks for noticing.

[@DADDYSJUICED20]

your hop up can be loose and outer barrel. thats what happened to me but over time using a different hop up when i tried the new one that kept locking up it worked fine. I dont know what happened to make it work but i think just using the gun so much over time it must have shaved away or done something the kept catching my hop up. maybe it was my slide not sure but from what i gathered the only thing that kept locking my slide was the maple leaf hopup. i had two other ones and the gun worked fine with my new barrel and outer barrel and stock tm hop up or we hop up. BUT like i said now i have the maple leaf in with no changes other than that the gun was used more and not fresh brand new.

[@papat4122]

@@DADDYSJUICED20 thank you so much ❤

[@MrBaghus]

you have placed the nozzle spring incorrectly. the narrowest part has to be left behind, which is how it turned out in the video. but you place it back with the narrowest side forward

[@lefishe3068]

Alroght so there was a ring on my nozzle and the plunger won’t go back with it on

[@e-tactix-airsofttrooper7491]

When you mean ring, do you mean oring? There are some plunger inside out loading nozzle where rather than a pad, they are orings.. you need to make sure they are fittrd correctly, and wont roll over causing loading nozzle jam...

[@lefishe3068]

@@e-tactix-airsofttrooper7491 no, it is more like a small metal ring.

[@e-tactix-airsofttrooper7491]

Oh!! The small very thin metal ring. If were talking of the same thing. Thats placed at the top of the blowback housing where the rear sight is bolted. Its like a spacer.

[@khajiit_fpv]

i dont have the screw unfer my rear sight

[@e-tactix-airsofttrooper7491]

@@khajiit_fpv double check it should have as far as i know. Its the one that hold the bbu "upward to the slide"

[@khajiit_fpv]

@ figured it out, Allen key on the rear of the slide. Having a problem with my o ring swelling