हिंदी में - Led night lamp Diy directly with 220 volt AC

📱"🔔" -
👉 Join Telegram Channel - t.me/craftocurrency
Like ♥️ Share & Subscribe 😊
Thank you for Watching 😃
#diyledlight
#diyledbulb
#diylednightlamp
#diyledproject
#diycrafts
#diy
#diyhomedecor
©️ Disclaimer
Copyright Disclaimer under Section 107 of the copyright act 1976, allowance is made for fair use for purposes such as criticism, comment, news reporting, scholarship, and research. Fair use is a use permitted by copyright statute that might otherwise be infringing. Non-profit, educational or personal use tips the balance in favour of fair use.
ㅤㅤㅤㅤㅤㅤㅤㅤㅤㅤ
Song: Jarico - Landscape (Vlog No Copyright Music)
Music promoted by Vlog No Copyright Music.
Video Link: • Video

[@rsubram24]

Very good presentation. I am going to do this.

[@premramram7277]

Super project sir ji

[@rsubram24]

One small question, if I use red or any other color do I have to change the resistor value?

[@ramadashbalasubramanium1849]

Very good job. Simple and economic project.

[@Craftocurrency]

Thank you very much 💐

[@ramadashbalasubramanium1849]

👍

[@AjayDas-hv5rm]

Nice work 👍

[@aglight6199]

Bahut hi badhiya hai 👍

[@Craftocurrency]

Thank you 💐💐💐

[@rubibhattacharjee9285]

Nice 👍

[@ckgaming625]

Super

[@Craftocurrency]

Thank you

[@subhasisdas8021]

Please show the ckt with all connection, if possible...

[@Craftocurrency]

Ok sir... Apni amar telegram channel e aste paren.. t.me/craftocurrency

[@mihirsahoo2797]

Heavy Glow chahiye to kya karna padega?

[@peparcraftwithsithu4644]

nice

[@dibacraftandart8483]

Nice

[@Craftocurrency]

Thank you 💐

[@nankashing985]

Agar ham isme 10 led laga de to kya ye chalega

[@Craftocurrency]

10 LED series में लगाकर केवल मात्र रेजिस्टेंस को 68 kohm कि जगह 22 kohm लगा दिजिए। बाकि diode का कनेक्शन वहीं रहेगा

[@SandeepKumar-dl5ml]

Can I use 56k registans

[@mbzumzum500]

Zasto nisi napisao vrijednost otpornika

[@Craftocurrency]

I have shown the value of resistance on the video. please watch the video again.. Thank-you

[@mbzumzum500]

@@Craftocurrency ok,upravu si...hvala..imas lajk

[@Craftocurrency]

@@mbzumzum500 Hope you have seen all my videos. If there are any errors in the videos, please let me know. Your comments are important to me. Thank you very much again

[@techsartamil4529]

LED - + connected diode not need and no action.

[@Craftocurrency]

The only reason to use a diode is to extend the life of the LED Thanks for watching the video 💐

[@mr.bullet6844]

​@@Craftocurrency​@Craftocurrency Hi sir hope you are fine. Sir I found your video today I followed it and made a circuit as you did. Sir my question is that you used a diode for the led and said that it'll extend the life of the led. Could you please explain this point. How this diode can protect it's life. I am 1st year student in electronics engineering. Please reply and explain it for my knowledge. Thanks in advance.

[@mehranabro6476]

2 led ka kese bnaege

[@Craftocurrency]

पहला LED ज़हां मैंने जोड़े हैं उसि जगह दूसरी LED जोड़ दिजिए

[@SandeepKumar-dl5ml]

220vlt pe id jata hai led

[@Craftocurrency]

You make this project. If you are not satisfied with the fabrication then you can tell me. But do not use vulgar language in words.

[@SandeepKumar-dl5ml]

I have checked every thing registans blast

[@Craftocurrency]

@@SandeepKumar-dl5ml I can't believe it. 🤔 Probably due to the wrong connection the resistance exploded. I do not upload fake videos. I am lighting this led light in my own room. Try it a second time and you will succeed. Best of luck. Have a nice day 💐

[@SandeepKumar-dl5ml]

Can I use 56k registans

[@Craftocurrency]

@@SandeepKumar-dl5ml Yes, 56 ohm resistance can be used. It is better not to use it below. Using resistance below this can damage the LED.

[@mohdarif7018]

Poor workmanship

[@vxnshikarajput]

👍

[@Craftocurrency]

Thank you 💐