Steve Cockerill of Rooster Sailing makes a basic repair to the gelcoat on a Laser transom.
Пікірлер: 11
@megasailor6 жыл бұрын
One improvement is to use a sheet of plastic taped to the hull. When you have painted the Gel coat onto the edge you can then, fold the plastic over the edge with the gel coat underneath and tape it tight to the hull. The Gel coat will not stick to the plastic when hardened and the edge will be the same rounded profile of the rest of the boat, saves a lot of sanding as well. Plastic sheets come from Office supply place - used for older overhead projectors.
@martinetkin25482 жыл бұрын
Another trick is to use mylar (polyester film) applied over the gel-coat to create an almost perfect surface.
@Andrew-qv2qu4 жыл бұрын
How long did you leave from applying to sanding? Ie drying time..
@gerdde42416 жыл бұрын
I dont' understand the last step. What was the material for polishing?
@davetreagust92736 жыл бұрын
Hi! We use a finishing compound called Farecla G3, available on our website here -> www.roostersailing.com/pd/Farcela-G3-Finishing-Liquid-Paste---400g_102518.htm
@nickmiller12263 жыл бұрын
If there are scratches?
@Ryansi2710 жыл бұрын
What was used in the last step ? Can't hear
@Ryansi2710 жыл бұрын
Thanks
@lorenzo65533 жыл бұрын
fur Eckler if u still care
@walkertongdee6 жыл бұрын
Whats a Bugget?
@technicstim6 жыл бұрын
should remove the tape about 20mins after you finish it comes away lovely then