Honwave t35 and t38 fishing and general messing about!

Fishing at ballygally Larne and the maidens Larne pollock fishing honwave sibs

[@stevesdaysoff2759]

Good video Ryan. Good to see you enjoying the T38. Hope the floor is working out for you. What's the width of the plywood you used. Did you round off the edges. Thanks Steve 👍

[@ryanferris7841]

Hi Steve thanks!! Still at the learning stages of making content it’s not easy lol, so the floor worked great however pre floor my t38 wasn’t inflated enough due to a dodgy pressure gauge, so after pumping to the correct pressure I found it really easy to stand up on the t38 without the floor and achieved speeds of 30 mph 🤯🤯 lol so I wasted my time and money, however I will still use part of the floor for the section of the sib where the V is more pronounce.

[@stevesdaysoff2759]

@ryanferris7841 Yes, to be honest, I find my floor ok to stand on with no problems. Just thought a small plywood piece might be a good idea to put one of them air chairs on. 👍

[@ryanferris7841]

@@stevesdaysoff2759 it would be great for your seat however you would only need a small section, yes I rounded all edges and put a support in the middle to support where the gap is 👍

[@stevesdaysoff2759]

My friend has uploaded a video of myself and him going around the island of Kerrera Oban in our T38s. His KZbin channel is Never late in a V8. Im the good looking one 😅

[@Wayne-ks9gd]

How did the wooden floor work out Ryan ?

[@ryanferris7841]

Hi Wayne, the wooden floor was great however I scraped the idea because I found that I can stand up on the t38 the very best 😂😂😂 I was running my boat at a low pressure due to a dodgy gauge, so I inflated properly and it was perfect also achieved speeds of 30mph no joke 🤯