How to allow or deny traffic between 2 LANs on pfSense

In this video I'll show you how I allow traffic between 2 LANs in pfSense.
www.pfsense.org/
Don't forget to check out my Discord server where you can talk open source operating systems and software
/ discord
#pfsense #OpenSource #Unix #garyhtech

[@Felix-ve9hs]

As I understand it, if you create a pass rule with the source of "DRLAN" and destination of "not DRLAN", then every device on your "DRLAN" network can access *any other network* - including your LAN network. What I would recomment is to use your RFC1918 alias, create a block rule, select "DRLAN net" as the source, "RFC1918" as destination with the inverted tickmark, this should do what you want to accomplish. :)

[@Felix-ve9hs]

The latter firewall rule only allows devices in the "DRLAN net" to access IP addresses and networks on the Internet.

[@uemotojp]

I didn't have your same problem with my networks, but I was at my wits end trying to make pfSense work in bridge mode for multiple computers. After seeing what you were doing at 2:35, I was finally able to get what I was doing wrong! Thank you for showing your problem and solution here!

[@GaryHTech]

Your welcome, thanks for watching, just glad I can help 😄

[@pirateradio1926]

Thanks again Gary, you have saved me a ton of time, less than 3 minutes and my question was answered

[@GaryHTech]

You are most welcome :)

[@ChristianMcDonald]

Great video Gary! Looking forward to more pfSense content from you

[@GaryHTech]

Thanks for watching :)

[@bruceallen6492]

God Bless you buddy, get well!

[@GaryHTech]

Thanks Bruce 🙂

[@JeremiahK]

This is what I'm trying to accomplish in the end, one way traffic between LANs. Do you have any videos that go over setting up the rules to allow traffic from your LAN to DRLAN? I'm using LAN & OPT2 and with OPNsense, but it should be similar I'd think. I set up a bridge and can ping from LAN to OPT2, but can't access the web interface of a printer from LAN to OPT2. I'm playing with different rules trying to figure it out. Edit: I did find a video where you set it up (and my attempt is similar), but it's not allowing traffic after bridging them. It seems like I'm missing something.

[@Martin-ot7xj]

Hi there, please make a tutorial video about how to block all traffic from outside or the internet into our network but from inside the network can access to the internet for more security on pfSense how we can create a rule on it ? thnx

[@karmakanic475]

Thanks for sharing, but yeah no I didn't get it and neither did you I believe lol

[@f1aziz]

I hope you're doing well.

[@GaryHTech]

I am thank you, I hope you are too

[@antarionaskurnatario6189]

Thank you A lot excessive talking... and its not solving problem for me...