Рет қаралды 98,660
Here is a quick demonstration of how to apply a boat stripe.
It is a basic waterline stripe using 50mm vinyl.
1. Clean the hull
2. Mark out the position of the stripe every metre or so
3. Apply the stripe in long sections at a time, short sections will result in a kinky line!
4. Squeegee the stripe down with an old credit card or squeegee.
5. Use a sharp stanley blade to trim the ends of the stripe, and to prick any bubbles, smaller bubbles will find their way out of the vinyl over a couple of days so don't go too mad pricking bubbles.
For stripes 75mm and over you can try 'soapy water', - use a 3 or 4 drops of fairy liquid in 1 litre of water, then when you remove the backing paper off the vinyl soak the sticky side of the vinyl in the soapy water,
Relax, good luck - you can do it!
Thanks for looking
Greg - The Wild Group