How To Apply Wall Stickers

[@joostvaneijsden6501]

Good Job James!

[@hartleyjr]

I came here to look at how to install a wall sticker we bought from you after struggling to understand the written instructions. There's no protective paper on our sticker, it's just two components. Would be good if you actually provided accurate installation instructions.

[@riveroakfitness]

Did u end up figuring it out.. mine also has just 2 pieces...

[@hartleyjr]

@@riveroakfitness no, just had to try to get one on the wall super plumb & without air bubbles & then try to line the other half up with the print. Given the stretch in the vinyl it's nigh on impossible

[@chrichtonsworld1]

Assuming all these stickers are the same there are three layers. But the trick is that you won't notice it until you have applied the sticker to the surface you want. Look at the example to see what's the front. Then peel of the backlayer. Then apply this to the surface (as straight as possible). The spatula is king in this case cause when pressed hard it can smoothen out any wrinkles or bubbles. I am not the most patient so I did it very quickly and even then result was stellar. Now the real tricky part. On my sticker there were two tiny cuts / lines one on the left and one on the right. Very gently peel one of those which is the third layer. If you used the spatula properly this third peel will come off easily but the sticker will stay in place. With properly i mean to remove all the air and bubbles

[@hartleyjr]

@@chrichtonsworld1 Trust me dude, it was just two layers