RvToyOutlet.com presents "How to Assemble a Folding Aluminum Cot" This instructional video shows you how to assemble a folding aluminum cot.
Пікірлер: 57
@AA-yk4dy3 жыл бұрын
11 years later... THANK YOU. Spent 20 minutes almost passing out trying to get that last notch in place! Grabbed a metal tube I had laying around and took 2 seconds to get into place. 👏 Thanks!
@jeansuify9 жыл бұрын
Thank you! I was able to set up the cot using your suggestions about stretching the fabric. I also sprayed it with water, first, based on a comment by playa2323, AND I used a small hammer handle (with a small piece of cardboard inserted between the handle and the frame) to protect the aluminum frame) as a lever as shown in the video. After the earlier frustration I experienced, including a tiny blood blister from where I caught my finger before I had your tips AND a chat with a Coleman representative (whose only advice was to return the cot to the store and buy one that wasn't so hard to set up!) I felt quite triumphant! I'm leaving it set up for the few days before my camping trip next week so I can continue to stretch it out here in the comfort of home. THANKS!!!
@bobz2996 жыл бұрын
Thank you for this great video. I have a Coleman River Gorge Cot I assembled for over a year now and forgot how to take it down. It is now after midnight and got no help at all from Coleman. Like one writer says, they are a waste of time. I had forgot how to get that end bar off. I remember it was a real pain getting it on for the first time, now I know how it comes off. Thanks again!!!!!
@margaretjerotich23413 жыл бұрын
I am in Kenya here can I buy the aluminum cot.
@Dragnmastralex5 жыл бұрын
WARNING NEVER USE A PRY BAR TO ASSEMBLE A COT. it will eventually damage it and cause structural weakness. instead stand the cot up on the end where the unattached side is on the bottom. step on the overlapping pole that you slide into the cot at the edge near the hole, then when your hands on the side frame push while you are stepping on it using the cot itself as a lever and it will lift the 2 apart far enough so that you can move it over the hole and when you let the cot go back, slide right into the hole. No additional tools required and you don't damage your cot with any prying tools.
@revelryband13895 жыл бұрын
best advice on here....took seconds to assemble after reading this.
@maryajones31475 жыл бұрын
I don't get it. Can you explain it like I'm a THREEYEAROLD?
@zackary87kr3 жыл бұрын
@@maryajones3147 Here ya go Mary. Just check the 01:30-02:30 of this video here. kzbin.info/www/bejne/nITJpKp9i8p4ibM
@raviechandrabulusu49904 ай бұрын
Good explanation of product.😊
@scottcoady48879 жыл бұрын
Thank you so much . This video helped me fix my problem with my Coleman cot. Their tech support was a waste of time.
@pimschaaf9 жыл бұрын
Nice to get some assurance that the typical aluminum cot can handle some leverage :) Thanks!
@101southsideboy14 жыл бұрын
only way to go camping. I have never found a air mattress I truly liked
@baveshkaran96293 жыл бұрын
Thanks for the tip! Helped me a lot.
@BerettaM9USAF14 жыл бұрын
Very helpfull video! Thanks to taking the time to put togather.
@playa32329 жыл бұрын
Thanks for the tip on the final segment of the cot assembly, I was kind of stumped on that. You can buy the large screwdriver at Sears, I have one, but I suppose a sturdy tent peg may also work. A woman named Christina told me if you wet the canvas fabric with water it will also help in the process. I am going camping tomorrow for a 6 nighter, I hope the cot will be better than a air mattress.
@waynethebarber10954 жыл бұрын
You should really talk about how the cot should be completely level. Shim the legs with 4x4 thin squares of wood, so the cot is level in all directions. If it is not you take a great chance in bending the side rails joints or legs. Never sit on an unlevel cot. You are only asking to damage it. If this helped you, please give me a thumbs up. Thank you.....
@He_So_Krayz3 жыл бұрын
In the army almost seven years at this point and I’ve never seen a cot with all the bars on. We just quit as an entire army
@AnimatedCardboard Жыл бұрын
2 years on, can confirm the British Army is also like this 🤣
@callmepr1176 жыл бұрын
Very good demo
@Montanaquilter11 жыл бұрын
Easy to understand. Thanks
@granttaylor48710 жыл бұрын
Where can u buy that massive screw driver!?
@v.s.rathore94399 күн бұрын
Price please
@windrivercountrykid14 жыл бұрын
Nice video,but I can't believe people wouldn't know the power of leverage,and that they would need help to figure this out.---again nice vid!!
@sariahlim8 жыл бұрын
I must be thick as two short planks because I needed this vid to disassemble ours... (wasn't there when it was put up and didn't realise it had detachable sections). Not bright. Thanks for the vid though, helpful for the stupid like me.
@HuplesCat6 жыл бұрын
Great. Needed this!
@dudearlo9 жыл бұрын
ive got some made of wood :D oldschool cots right there
@harrisonrk6 жыл бұрын
Thank you!
@josemorquecho63937 жыл бұрын
Thank u big help!
@Rickhowd13 жыл бұрын
A true cot is much tighter and needs a GP M peg to turn it.
@nikkaelalaggui46494 ай бұрын
Saan pwd mag order
@prakashkumerdey50984 жыл бұрын
Hi, very nice.. What is The name of the cloth used here? Please inform me
@owain89007 жыл бұрын
Thank u so much
@nurunnobi71295 ай бұрын
কোথায় পাওয়া যায়
@maxwaerens8218 жыл бұрын
DAT SCREWDRIVER !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
@crabtrap3 жыл бұрын
i was hoping for some 'trick' to the last pole corner......the screwdriver is also what i used BEFORE watching this. good vid tho
@0ption_Three8 жыл бұрын
I have an odd question.. Does anyone know how to stop the material from stretching so much? Literally sinking while laying on it and touching the cross bars underneath.. The ones we had in the military had small extensions on the bars on each side so it would stretch out the material a tad bit more. Those were always tight and taunt. Not like the one I own now... Any thoughts?
@dianebassett19305 жыл бұрын
Tyler Winton try wetting the canvas thoroughly, then using a blow dryer to shrink the fabric back up
@prineful10 жыл бұрын
How mutch does one of these things weigh? Im 14 years old and want one for camping.
@ht3oldnavy9 жыл бұрын
just over 17 pounds
@user-bj1gu4ed6m3 ай бұрын
এটার দাম কত
@fordgt40211 жыл бұрын
Can i just omit the support bars?
@SrikantRZradio5 жыл бұрын
u need that . it will collapse if missing
@maidadutcher89237 жыл бұрын
Im using ShepherdSurvives instructions to all my surviving ideas :)
@DobermansRock11 жыл бұрын
Now it just needs a Thermarest mattress.
@mr.quiltworth8459 жыл бұрын
Sitting on mine watching this video
@user-lb9nt1bb2k10 ай бұрын
😅price
@diamonddom155 жыл бұрын
Is it just me or do we all have the same cot
@TWJfdsa6 жыл бұрын
2:30 is the hard part
@user-ji7zt4yk2o5 жыл бұрын
يا الله
@lokmantas72966 жыл бұрын
BANA BİR ADET LAZIM
@DobermansRock11 жыл бұрын
ThermaRest
@vasja123342 жыл бұрын
Shit quality. Legs metall 0,5mm. If you sit suddenly in the middle, the legs deforming. I have 2 similiar beds, and both damaged.