How to Assign DSL40CR Master Volumes to Each Channel

[@markwaley7859]

Great Tutorial!!! This is how I run my DSL40CR... As everyone that owns one of these amps knows, the Classic Clean and Classic Crunch are not balanced. What I mean by that is: the Classic Crunch is considerably louder than Classic Clean. On the other hand, Ultra Gain Green and Ultra Gain Red are balanced well and are just about the same volume. I assign the Classic Clean (Green) to MASTER 1 - dial in the volume as required. I assign the Classic Crunch (Red) to MASTER 2 - dial in the volume as required. I assign Ultra Gain Green and Ultra Red to either of the MASTER's, but they have to be to the same one. Adjust Classic Clean with MASTER 1 | Adjust Classic Crunch with MASTER 2 | Adjust either | both Ultra Channels with the CHANNEL Volume Knob. That's the trick here. Use a clean boost for leads. DONE....

[@TheCleaner6969]

Thanks! You added some great info thank you. I hope others will find it as useful as I do.

[@asadnazim6827]

Love your voice. Sounds like my old magic teacher.

[@TheCleaner6969]

Thank you :)

[@thekenandmisty]

Thank you for this it is very helpful.

[@TheCleaner6969]

You're welcome. I'm glad it was of help

[@kyousuke8512]

So I'm not going to lie, I made it about a minute into this video and I was thinking "this guy is an idiot, he's just talking about how the leds are the same color"... and then it clicked "damn, I'm using this amp wrong". THanks for making the video!

[@TheCleaner6969]

You're welcome. I'm glad it helped you out!

[@deanmccaskill5495]

I mean….. I have this $&@$ing thing. I pressed buttons until it sounds ok…. Then I went right back to my Princeton or Deluxe Reverb. The 40C collects dust mostly

[@aitken1965]

Da Bears...

[@hemipirate]

Me, colorblind and laughing at myself, again...

[@kyousuke8512]

Yeah I’m not colorblind but I was thinking red and green was a deliberately poor choice on their part

[@gill.5116]

I wish there was a way to combine them to be able to use the guitar volume

[@TheCleaner6969]

That would be a nice feature

[@gill.5116]

@@TheCleaner6969 I have this amp and I also have the six channels foot switch which is nice but it’s a little bit overkill since I don’t use the effects loop, I also have a foot switch like the one in your demonstration. The issue is that only governs one channel, say, for example, clean and crunch, and the particular master, volume correct or can you programmed to do a couple of channels

[@TheCleaner6969]

@@gill.5116 You are correct if I understand you. You can only set 2 channels with whatever the Master Volume is no more programming can be done.