How to: Change Differential Bushings On A 350Z

In this video, we show you how to replace those old worn, and cracked front and rear differential bushings on your 350Z. We even added some spice and replaced the differential cover as well.
►Z1 Urethane Rear Differential Bushing Set: www.z1motorsports.com/z1-prod...
►Z1 Rear Differential Bushing Removal Tool: www.z1motorsports.com/z1-prod...
►Z1 Motorsports High Capacity Differential Cover Kit: www.z1motorsports.com/z1-prod...
►Subscribe here: z1m.io/SUBSCRIBE
Like us on Facebook: / z1motorsports
Follow us on Instagram: / z1motorsports
Click here if you want to learn more about Z1 Motorsports: www.z1motorsports.com
Nissan & Infiniti Specialists - The World's largest selection of OEM, Performance & Aftermarket parts to Maintain or Upgrade your vehicle.

[@thadanielshow]

You should do a 4.09 final drive diff upgrade video. Include testing of 0-60 before and after. There’s alot of mystery out there without any hard numbers besides a handful of forum posts from over 10 years ago. Almost nothing on KZbin either. If people knew the 4.09 or 4.36 gears can drop the 0-60 on a 350z by a full second, people would be buying more of these. Suggest you do it on a DE car. Testing 0-60 before and after with the dragy app.

[@bigtings3613]

Just when I’m in need of a diff bushings z1 has came thru with a detailed vid 👌🏼

[@youngandballin92]

You got extremely lucky. I was smacking those bushings out for about a half hour. Then I finally brought out the air hammer and torch to help. Still took some time. Pretty sure mine were worse than normal though.

[@bradenjones4708]

24:27 the large nut for my remover tool didn’t fit into the channel

[@brendanchestnut9805]

Y’all always leaving jerseys on my clean floors when y’all work on David’s car.

[@louellachang4046]

how much would this whole job cost?

[@slfrules1]

Gotta put some anger behind Wilton!

[@dustinsamson4879]

I have never heard of scotchbriteing the new mating surfaces. Is this something you should really do?

[@Z1Motorsports23]

If it's a brand new cover, it is not required, but helps the RTV create a good seal.

[@Clxssy56]

I can’t get the mounting bolts to go in at all any solution?

[@Z1Motorsports23]

Your captive washers in the subframe may be stripped. In that case, the only solution unfortunately is to replace your subframe.

[@rororobo]

They aren't threading in, or you can't line the bolt holes up with the new bushings?

[@FrankieJ1981]

I need this done to my G35 from Jersey and mine looks like that also, I should bring mine down since you are good with rusty cars from Jersey 😂

[@Z1Motorsports23]

We have a loootttt of practice from Dave’s car 😂

[@FrankieJ1981]

@@Z1Motorsports23 😄

[@dustinsamson4879]

Wouldn't the top hole be a fill hole? Bottom is drain and top is fill

[@Z1Motorsports23]

With the Z1 Dif Cover, you get a fill hole (top), drain hole (bottom), and an additional hole in case you want to install a diff cooler.

[@rcghalohell]

I think that's worse than the "z1 test car" Jon bought from me back in 2018