How To Change Rear Disc Brakes with Integrated Bearings | Renault Clio IV R.S. EDC

[@thelanehunterdevon1664]

Good video

[@easywork2]

Thank You

[@obebodd5066]

Nice video man, Did the rear discs and pads. Seems to be working fine but my handbrake was very loose to begin with, I adjusted the cable under the centre panel, it's a lot stiffer now but the the rear calipers won't brake while using handbrake. Have any idea?

[@easywork2]

Hi, based on what you're writing, your handbrake mechanism is probably stuck.Raise the vehicle and observe the movement of the cable. Focus on the movement in the brake caliper. If it is stationary, it is stuck. If it is moving, the handbrake must be adjusted.

[@obebodd5066]

@@easywork2 well, they worked perfect before the brake change. I can see that both cables have movement. I took a look at the caliper, took off the handbrake caliper from the actuation arm and tried it manually. When I move the arm manually and spin the disc at the same time it doesn't lock the brake until at the very end when I press very hard. So basically only the very end of the movement of the handbrake arm does lock the brake. Is there any adjusting in the caliper itself of this actuator arm?

[@easywork2]

@@obebodd5066 How much did you drive on it? The handbrake should adjust itself. If it doesn't adjust itself, you have to adjust it manually. Unfortunately, I don't have such a video on my channels yet, so try watching another channel.

[@obebodd5066]

@ om not sure what you mean by brake discs oil cap. Could you specify?

[@bionikatomik9736]

Where you top up the brake fluid, usually when I change the front pads I always remove the lid so that I don't have to bleed the oil brakes, doesn't need to there new. ​@@obebodd5066