How to clone DiTEC and V2 Phoenix remote control clone, key fob (side by side)

Simple 5 Step Programming Instructions
1) To delete the existing code of the new remote: ( A button has lock symbol -- B button has unlock symbol)
Press the keys A and B at the same time until the LED quickly flashes 3 times; Do not release A button but press B button 3 times until the LED flashes 3 times, then release both keys.The new remote is ready to copy the code (Now, if you press any button RED LED WILL NOT FLASH. REMOTE IS CLEAR)
2) Enter programming mode - Hold down buttons A and B until the RED LED flashes 3 times.
3) Place the original and the clone remote close together.
4) Press the button to be programmed on both remotes and hold until LED flashes steadily on the clone remote. (The led will flash 3 times at interval whilst programming is active but will flash continuously once programming completed)
5) Programming is complete - Repeat steps 2-4 to program extra buttons

[@ruitfsilva]

Thanks very much, was having trouble whit my universal remote.

[@shouldbelikethat]

Thanks! This helped me a lot.

[@TinC33]

Thanks

[@hodayatovi1979]

very helpful to compare to ebay explanations, but somehow it works just one each time - i programmed all 4 buttons to do the same - lift the gate to the parking (then i closed after 30s). each button opened it, but just once.. what did i do wrong?

[@usernameDataText]

It means that your remote uses "Rotating code", it's very hard to clone. The code of the key and the gate are different at every use.

[@usernameDataText]

(had the same problem btw, no simple solution found yet)

[@c.b.271]

Come resettare il v2?

[@alessandrorodio6800]

servirebbe saperlo anche a me

[@ceylacjerome6274]

Merci car la notice accompagnant l'envoi est inexacte