How To Control Your Instrument in LabView without a driver

[@howdie91]

Can't read what you wrote for the write buffer because resolution is too low.

[@pirateradio8420]

I'm trying to use SCPI commands to control an instrument over a TCP/IP interface. What was not specified in your video was the physical connection between Labview and the function generator. How were you able to simply select the device from the pull down menu?

[@pavankumarpolisetti210]

Can you tell me how to write SCPI commands/ where I can learn? please

[@peytonclark2476]

how can we troubleshoot if we don't see the device how up from the pull down menu? My device is connected via a RS-232 cable and plugged into power.

[@suijinnoname6412]

I am very much a novice but your device should show as a COM port in the pull down. If not then you are missing a driver or something more basic. NI has resources for finding drivers like IDnet to devices or go to the manufacturer.

[@TheAmpNerd]

This is a bummer. I would think it would be a little bit better and some resolution so that we can see what is being done. Also, it's nice to be talking directly to the instrument, using what interface? What are the connection points etc? As the video shows Visa's O-W-R-C being pulled do the block diagram how are they interfaced to the Front Panel. Things are popping up which I cannot see and then lines being drawn between them and the Visa O-W-R-C's. How is this accomplished.

[@pavankumarpolisetti210]

i need the SCPI commands for configuring and reading the configured values. Tell me where i can learn/get that info

[@KeysightHandsOn]

Pavan Kumar Polisetti. The instrument manuals have the SCPI commands and typically some example programs. The manuals are usually available on our website for free as pdf.

[@RedHeaded411]

@@KeysightHandsOn, that last line isn't, and that's needed for the Read node right?

[@toddwilliams2390]

Please paste your code here somewhere

[@xXicecream9995Xx]

Is this code posted somehwere

[@racm2023]

It's too blurry to read. Gave me a migraine x_X

[@yonsebastiantorres7248]

Basically is talking directly to measurement device which is in the command mode....

[@paytonferguson7316]

This would be good if it wasn't recorded using a toaster.

[@amandaestelarodriguez9210]

MP MMX no IP MP