I have seen tons and tons of tutorials and none of them tells you this good on how to place the mass you create with the walls. Thank you
@MashyoCom6 ай бұрын
Thanks Wendy! I'm glad it was helpful and sorry for the late reply.
@abigaeldavid41486 күн бұрын
when are you going to post again.. this tutorial helps me a lot in my project exploration. hope you continue making revit tutorials
@arproduction545425 күн бұрын
I like your way of explaining. Kindly make videos on the complete Revit project on the following topics: the complete design and modeling of: a) Modern house b) residential buildings c) complex buildings d) airport design e) railway station design f) metro design g) hotels modeling and design h) restaurant design and modeling I) Motorway design j) shopping mall design k) hospital design l) university campus design m) high-rise building n) fancy tower design o) bus terminal design
@candydvg.963517 күн бұрын
Thank you so much. you save my life
@assemacallenreese9896 ай бұрын
Thank you so much!! This tutorial is really helpful for me
@ananyasingh12925 ай бұрын
BY FAR THE EASIEST.
@nabilahanin30924 ай бұрын
Hai, i was followed step by steps but i can’t make create from. And after click created from “unable to create from element” comes
@nolanyoung17996 ай бұрын
When i went to create my roof… it would not allow me to select the form after clicking roof by face.
@MashyoCom6 ай бұрын
Hi Nolan. This can happen if you create a steep roof curve that Revit cannot translate into a roof geometry. The solution is to make it more of a "roof" with less extreme curves, or you can try "wall by face". If the problem persists, upload a screenshot of your 3D shape and paste its link here and I'll try to help you further.
@nolanyoung17995 ай бұрын
@@MashyoCom how do i then join walls below to the curved roof above?