How to cut and bleed Sram level hydraulic brake line.

[@flaviomarzocchi7444]

OMG! YOU HAVE INSTALL THE RED OGIVE UPSIDE DOWN. YOU HAVE DESTROYED THE BRAKE. I CAN T BELIEVE😂

[@flaviomarzocchi7444]

Hai montato l ogiva rossa al contrario non ci posso credere

[@Chudozvon]

You should have removed brake pads before bleeding and have used a special spacer in order not to contaminate the pads with DOT liquid, buddy... If they have been contaminated, no spray cleaner will help you

[@LegacyHandyman]

thank you for your comment.

[@jesperlsorensen]

hopefully, people see these comments, before they use your video for DIY bleed service

[@Joachim_B83]

Why do you make a guide when you don`t know what you are doing? check out sram`s videos on how to do this the right way.

[@register1430]

you did not show the CUT or the reason to cut. This does not look very legit way.

[@MrSuperSkoter]

WRONG! 3 minutes in in the video you're installing the red compression gasket up side down! It should be screwed on from the other end...

[@jesperlsorensen]

correct. i was wondering about the same

[@Dj9oh5]

Yea my dumbass didn't read the comments before installing the compression fitting... luckily I didn't tighten more than finger tight before thinking it didn't seem right as the aluminum would crush under compression. I looked at a true SRAM install video and confirmed my suspicion. Please do your research as those fittings are one time use.

[@florchomes]

Fuera pastillas!!!

[@gorgon4061]

With all due respect, all wrong.

[@ЛёхаБукреев]

Русский? =)