Have you check the defection angle , where is lane marking, have you the all visibility analysis
@Civil3dpro043 ай бұрын
Its was just basics overview for a client to explain little about roundabout
@CAD_Lecturer Жыл бұрын
Nice one
@Civil3dpro04 Жыл бұрын
Thank you
@KamleshDhaka0017 Жыл бұрын
Sir mouza map ya jameen ka naksha ko satellite image per kaise set karte is per video banana
@Civil3dpro04 Жыл бұрын
Already youtube pe iski video pari hn, agar per b apko chaye to m bna donga
@KamleshDhaka0017 Жыл бұрын
@@Civil3dpro04 Sir video bna do🙏🙏
@mikemaps944 ай бұрын
How do i drawing roundabout for left hand traffic without having to put in data that opposes the approach and departure lane
@Civil3dpro044 ай бұрын
Use another criteria file or systems for left hand, You will get them in roundabout dialogue box on 1st page
@peterkiptum5783 Жыл бұрын
Hello sir, can you please post the data points to assist in following up what you are doing
@Civil3dpro04 Жыл бұрын
Which data points you are asking? Do you need survey data to create surface??
@peterkiptum5783 Жыл бұрын
@@Civil3dpro04 yes
@Civil3dpro04 Жыл бұрын
@@peterkiptum5783 you can contours surface or survey data from chapter-1, go there on chapter-1 videos and find drawings and survey data in description of each video
@Civil3dpro04 Жыл бұрын
@@peterkiptum5783 otherwise contact me at my social media then i will send you data
@burakylmaz1034 Жыл бұрын
@@Civil3dpro04 c3d 2020 has these properties and utilities ?
@fitsybitsy81818 ай бұрын
After creating the roundabout with roundabout tool, problems i faced- 1. If inscribed circle Dia is changing, then center island Dia also changed and roundabout got created but it says road width for wb-20 too small. 2. after creating 1 approach, for rest of the approaches, not able to select alignment for approach. please suggest.
@Civil3dpro048 ай бұрын
For the first problem, ensure that the road width for the westbound approach is adequate to accommodate the changes in the roundabout's dimensions caused by variations in the inscribed circle diameter. For the second issue, double-check that the alignment selection process is correctly applied to all approaches. Ensure that the alignment selection procedure is consistent across all approaches to avoid any selection errors.