How to design zirconia bridge on titanuom bar in exocad3.1

[@christopherpereira9053]

Thank you for sharing your knowledge! The world is a better place with people like you.👍

[@nahidkarami534]

Hi Dr Vafaei Thanks for your education.

[@aroncarvajal7080]

Hi Dr can I make a suggestion if you leave a little more room on the vestibular area so that you can add a about a millimeter of porcelain your restauration will look a lot more natural and esthetic I know now in days people are using all types of stains and glazes without porcelain but to tell you the truth until now nothing looks better than porcelain.

[@CadistaTorres]

excellent work

[@sashikokaramazov7684]

Спасибо

[@drsatyabodh]

At what step we have to save the screws to get them here for subtraction? Thank you for sharing knowledge 🙏🏻

[@user-le9ro4wy4g]

Thank you for your content 🫶🏽 Question... Just curious how necessary it is for one to have a ti bar substructure, with a monolithic Zirconia restoration? Being the superior strength of the product you know. Also do you get many requests for this type of prosthesis? Rich

[@machewbacca]

It's not, I would only use a bar with zirc if the restorative space was an issue

[@eu3145]

how you save the screw channels to keep the same position when loaded?

[@machewbacca]

save everything as STL's in the same coordinate system

[@drsatyabodh]

I tried to subtract the round shaped rod from attachments pre formed library, but it didn’t make the hole through and through ….