How to fish the Slider: Mainline Match Fishing TV -

  Рет қаралды 13,792

Mainline Match Fishing TV

Mainline Match Fishing TV

Күн бұрын

Пікірлер: 34
@davidhodgson1385
@davidhodgson1385 4 ай бұрын
Proper angling, great video as always Matty 🎣
@carpmasterherman
@carpmasterherman 4 ай бұрын
Hello Matt first thumb up is from the Netherlands.👍👍👍
@christophersmith3338
@christophersmith3338 4 ай бұрын
Great Angler full of knowledge 👍🏻
@davidhodgson1385
@davidhodgson1385 4 ай бұрын
When are the guru slider floats coming out ?
@YoungBlondeDon
@YoungBlondeDon 4 ай бұрын
Sooooo, when are the guru sliders coming out? Just saying what everyone’s bee thinking since Matt posted them on insta.
@johnsmith-px1sr
@johnsmith-px1sr 3 ай бұрын
6:01 did you squoze them tightly?😂..great new addition to the oxford english dictionary. i must remember that word👍
@chrisfox5153
@chrisfox5153 4 ай бұрын
Where can I get your slider floats please Matt
@martinhassall7884
@martinhassall7884 4 ай бұрын
Hi great video as normal the thing i still struggle with is the initial getting the correct depth as in this video your using a 13ft rod but the depth a few feet deeper do you just use the so how can you put on the stop knot when on your first cast you find the depth when the float reaches the surface itll obviously be longer then the rod so as you wind in dont you loose the depth or do you have to keep moving the stop knot until the float appears so it may take a number of casts?. Hope ive made sence
@stevemccrory9130
@stevemccrory9130 3 ай бұрын
Easy start point is to set your 2 stop knots at the joint between the butt section and middle section, on the line that is running through the rod rings. Unless you're really familiar with the venue, this will give a knot depth of around 18-20ft on a 13ft rod, and a little deeper on a 14ft one. Yes, it will take a few casts to get it right. If your float doesn't appear, the knots need to be moved further away from the reel. If its showing too much then move them towards the reel. Putting on a bigger float body will also help create the vertical from bulk to float, and this shown in Matt's other video over on the Guru channel (#26 on the Bitesize playlist).
@martinhassall7884
@martinhassall7884 3 ай бұрын
Ok thank you very much for your reply much appreciated.
@geoffreystockton7639
@geoffreystockton7639 4 ай бұрын
How long was the shock leader was the slider on the shock leader
@stevemccrory9130
@stevemccrory9130 4 ай бұрын
Around 20ft, or 6m. This allows for a couple of turns of leader on the reel (say 5ft / 1.5m), the usable length of the rod above the reel (say 11ft / 3.3m) and the drop from rod tip to float before the cast (4ft / 1.2m). Matt was using a 4lb (0.20mm) mainline and explained the 8lbs (0.28mm) leader was there because of the possibilities of tangling the rig. The lighter mainline may have been used to reduce drag on the line because of the wind / tow scenario Matt decribed - left to right wind creating right to left undertow. It also provided stiffness in the majority of the rig which would cut down tangles in the side wind. There are 2 ways of setting up a slider rig with a leader..... 1. In the way described in the video, with a long shock-leader to a lighter mainline. The olivette needs to be locked onto the leader with the shot above and group of shot below. The set-up means the stop-knots would also be on the leader as well as the float. A great set-up when the depth is 20ft or shallower (Matt said the depth was 16ft). 2. Deeper swims sometimes need a different rig - one with a heavier mainline (normally 5lbs / 0.23mm or 6lbs / 0.25mm) to a much shorter leader. The heavier mainline would give the durability and reliability during the cast and retrieve, and the stop-knots (same breaking strain / diameter) would be tied onto the mainline. The leader needs to be only a metre long, and the olivette sits over the loop-to-loop knot connection between mainline and leader, again locked on with one shot above and a few below. The leader can be either normal mono or flourocarbon, and the olivette hides the 2 loops inside it's bore. The dropper shot are on the leader too, and it is finished off at the bottom end with either a swivel or a quick-change hooklength swivel. Because of the leader, and the distance of the olivette from the bottom swivel, shorter 6 or 8 inch hooklengths can be used. Another plus of the shorter leader is that the line below the bulk will be stiffer and less prone to tangles in the deeper water. The boom of shot below the olivette and the stiff line of the shorter leader keeps the hooklength away as it sinks. A video and description of this rig (#2) can be seen and heard in the GURU video Matt did on slider fishing at Damflask Reservoir, also just outside of Sheffield. KZbin won't let me add a link.
@michelmilan1
@michelmilan1 4 ай бұрын
@@stevemccrory9130 kzbin.info/www/bejne/e6LKaaxtj554qK8
@michelmilan1
@michelmilan1 4 ай бұрын
@@stevemccrory9130 kzbin.info/www/bejne/e6LKaaxtj554qK8
@vincedowling4777
@vincedowling4777 4 ай бұрын
what knot are you using to connect the shocker to the main line please?
@stevemccrory9130
@stevemccrory9130 4 ай бұрын
Unlikely to get a response from Matt - he's on his way back from Slovenia - but the loop-to-loop is the one I'd use. Pass the mainline loop through the shock-leader loop and the other end of the shock-leader through the mainline loop. Have the 2 loops about 40mm long in total and trim the tag ends tight.
@dustymiller3419
@dustymiller3419 4 ай бұрын
Great video but I’m a little confused. 14:50, you say that it certainly DOESNT help?? Why use it then?
@kevinbeardsworth3756
@kevinbeardsworth3756 4 ай бұрын
Ye you tell by they way he said it that he said it wrong. Think he meant to say it certainly helps.
@KevinBland-h6m
@KevinBland-h6m 4 ай бұрын
Why have the Olivette upside down?
@christophersmith3338
@christophersmith3338 4 ай бұрын
I thought that 🤔 will be a valid reason with MG !
@stevemccrory9130
@stevemccrory9130 4 ай бұрын
It falls through the water more efficiently, and it sits better with the smaller shot below it. Rig dynamics #1. When casting, the bulk of the float (3g) and the heavier end of the olivette are together through the air. Rig dynamics #2. It moves the centre of gravity of the olivette away from the hook more. Reducing rig resistance. Rig dynamics #3. The hook, swivel, droppers, group of shot below the olivette and the olivette get progressively heavier. Rig dynamics #4. Put the simplicity, efficiency and dynamics together and the peformance of the rig is maximised.
@christophersmith3338
@christophersmith3338 4 ай бұрын
@@stevemccrory9130 thanks Steve well explained 👍🏻just one question. The slider knot double loop overhang knot and best gauge of line ?
@stevemccrory9130
@stevemccrory9130 4 ай бұрын
@@christophersmith3338 There is a specific knot for the stop-knot. I'll try to explain it. Take a 10inch piece of line, the same diameter as the mainline is ok, and fold it in half. Hold this next to the mainline with the tag ends pointing towards the rod tip and wind one of the tag ends around the other 2 pieces of line 7 times (for luck). Pass the tag end back through the loop created when you folded the free piece of line over. Moisten and tighten slowly onto the mainline. The 2 tag ends should come out of the tightened knot in opposite directions, but should also stand away from the mainline. Trim the two tag ends to about 40mm / an inch and a half. Repeat for the second knot, either above or below the first. As Matt says in the video, put a small bead on the line between the stop-knots and the float. This will butt against the knots and prevent (heavens forbid) the float passing over the 2 knots, and 2 knots are more secure than one. There is another slider video Matt did, over on the Guru YT page, under the Bitesize playlist, that shows you how to tie it. Its Bitesize video #26 in the playlist, and the demo starts at 6:00 into it. It is probably better to watch this than try and follow my typed instructions, but I hope this helps. Like he says, practice makes perfect. YT won't let me add the link to the other video. Apologies on their behalf.
@christophersmith3338
@christophersmith3338 4 ай бұрын
@@stevemccrory9130 great info again Steve. Yes I do recall that video think it’s the one at Rudyard. I will give it a watch 👍🏻
@antrog1895
@antrog1895 4 ай бұрын
Squoze… hmmm 👍
@stevemccrory9130
@stevemccrory9130 4 ай бұрын
Yorkshire. Nuff said.
@antrog1895
@antrog1895 4 ай бұрын
@@stevemccrory9130 😆
I Caught My Biggest Ever Fish! TWICE?!
39:29
Fish With Carl
Рет қаралды 775 М.
HOW to catch BIG OLD CARP - Walthamstow reservoirs
23:48
Alfie Russell’s Angling
Рет қаралды 25 М.
Beat Ronaldo, Win $1,000,000
22:45
MrBeast
Рет қаралды 108 МЛН
Мясо вегана? 🧐 @Whatthefshow
01:01
История одного вокалиста
Рет қаралды 4,4 МЛН
coco在求救? #小丑 #天使 #shorts
00:29
好人小丑
Рет қаралды 86 МЛН
Pole Fishing Southfields Reservoir: Mainline Match Fishing TV -
22:39
Mainline Match Fishing TV
Рет қаралды 30 М.
Slider Fishing Masterclass | Alan Scotthorne | Match Fishing
15:01
Drennan Tackle
Рет қаралды 43 М.
Fish Down the Margins: Mainline Match Fishing TV -
1:12:46
Mainline Match Fishing TV
Рет қаралды 29 М.
Fishing Your FIRST EVER Match! | Andy May's Basic Guide
12:25
Winning Ways Basics
Рет қаралды 11 М.
Deep Water Slider Float Fishing | Weston Pools Clay Pit | Andy May
20:15
Slider Fishing - How to Set Up a Sliding Float
16:10
Fishing with Den
Рет қаралды 46 М.
Catch More Fish on the Waggler . Mainline Match Fishing TV -
24:57
Mainline Match Fishing TV
Рет қаралды 23 М.
Cap Fishing Off The Surface! | Jamie Hughes vs Andy May
28:49
Winning Ways
Рет қаралды 97 М.
Fishing in the UK's Biggest City!
21:42
Tom Wilshaw
Рет қаралды 271 М.
Float Fishing Masterclass - Bodied Waggler
41:32
Cadence Fishing UK
Рет қаралды 77 М.
Beat Ronaldo, Win $1,000,000
22:45
MrBeast
Рет қаралды 108 МЛН