How to fix a broken beyblade X string launcher

Update: I made a follow up video about how to stop your launcher breaking
• How to stop your Beybl...
My beyblade X launcher broke the same day I got it, but I figured out how to fix it, if yours broke the same way mine did, I hope this can be of some help.
My launcher manufacturing ID is A2.
Music: Mornings
Musician: Jeff Kaale
#beyblade #beybladex #howto

[@galactic-beys]

Great video🔥🔥🔥 the friction gear from old mfb launchers is like the perfect thickness to cut 2 small pieces from and place them into the slits where the spring get sucked into the housing, i use glue from a glue stick to keep them in place. i made a long string l/r mod tutorial and show that spring mod👍

[@banjaxed8334]

Nice, I'll definitely do that if it happens again.

[@blakkthundder7902]

I realized with this vid that you can fix it no matter if the coil isn’t looking the way as advertised but as long as you have the prong holding it tight so it can coil before putting back the white gear back into the launder

[@Pans_Beyblades]

Epic vid

[@MyrzaOffical]

My launcher ACTUALLY broke. I mean the middle coil split from the outer coil. I tried to fix it but its impossible. So i need to buy a new one

[@Ericksonluka]

how do you tighten the spring the one part you didn't show was the part of putting the rod back through the spring and when you tighten it it free spins so how do you tighten the spring if the axel through it is just spinning?

[@banjaxed8334]

Yeah I didn't have good footage for putting it back together unfortunately. But if the the axle is free spinning then it probably isn't put in right. If you look at the spring you should see the fold at the centre, put that part of the spring in the slot of the axle when putting it back together, so when you twist the axle it tightens the spring. Hopefully this helps:)

[@Bob_cheezyman]

My spring on the launcher broke cuz i spinned the spring the wrong way😢

[@Xel_games]

Everytime someone makes these they do not show how to rewind the spring. I can't tell by looking at your's how this should be an mind has bends in it that no one else's does. An i didn't bend it or mess with it once it was out. It just unraveled like this.

[@banjaxed8334]

Ah yeah ideally the spring doesn't come out. But to put it back in first you should try and straighten the bends, or if its too damaged cut off the damaged section (assuming its just a small section of the inner part) and create a new loop to hold the central tab. Then to put it back in the casing, find the end of the spring with a notch bend in it, put the notch on the tab as I show in my video, and start putting it in through the gap in the casing. Then you just wrap the spring around from the outside in, filling in the casing.