How to increase/decrease counter value using cursor or function keys. Siemens LOGO PLC tutorial.

Another quick Siemens LOGO tutorial how to increase/decrease counter value. Single hit cursor ↑ key will increase value but holding the cursor ↑ for 1s increments the value continuously until you release the cursor key.
Like, subscribe and don't skip the ads :)
Siemens LOGO tutorials :
▶️ • Siemens Logo PLC progr...
Electrical Wiring and diagrams :
▶️ • Electrical Wiring and ...
#SiemensLogo #plctutorial
Disclaimer:
This is example program. I can't under any circumstances be held liable for any possible personal injury or material damage resulting from the use of this program.

[@Elecnova]

good video, helps me a lot!

[@orlandoserrano4275]

Good video!

[@ukrolelo]

Hi, but this is in simulation, in real you need to hold the ESC but it say protection message block and if i remove protection it will go dark after holding esc for 2sec to edit the parametr. I am not able to make it work in real LOGO. Please advise. Have you tested it on real LOGO?

[@derekmorrison1973]

Hi I have been using the logo software v8.0. I am an electrician so prefer ladder diagram. However, I find the page is too short for the programme I have written so far and I require to add more rungs but don't know how to do this. Can you help me here please?

[@alawyalhosani18]

thanks

[@raheels.1068]

HI VERY GOOD VIDEO. HOW I CAN CHANGE TIMER TIME WITH CURSOR KEYS ??