How to Install a Blue Diamond Condensate Pump on a M-Series Wall-Mount Unit

  Рет қаралды 68,356

Mitsubishi Electric Trane US

Mitsubishi Electric Trane US

Күн бұрын

Пікірлер: 25
@chesterguerrero8312
@chesterguerrero8312 11 ай бұрын
The fact that you show how to actually wire your pump puts you guys waaaaay above the rest! Insane how this isnt shown with other guys pumps (aspen pumps) 😮😅
@Sevendaver
@Sevendaver 4 жыл бұрын
I just had 3 MSZ-AP15VG / MSZ-AP20VG installed in the bedrooms the pump makes enough noise to wake me up at night.
@ACservices512
@ACservices512 3 жыл бұрын
So where is the 1 amp fuse per the install instructions?
@josbrun
@josbrun 3 жыл бұрын
The reservoir is very delicate, I’m using soft silicon tubing, not to put too much pressure on the stub-outs. On the pump, the outlet stub-out is too close to the body of the pump. Not enough room for hose clamps, I’m using zip ties. Get rid of the factory drain house, use 10” section of 1/2” silicon tubing to connect the reservoir.
@Rodriguez188
@Rodriguez188 3 жыл бұрын
What happens when you have to replace the pump and you don't have access to the back of the unit? Can you pull the unit off the wall to replace the pump?
@Dan-hd3cs
@Dan-hd3cs 2 жыл бұрын
I had the same thought. I was installing an MSZ-FS09NA today with a this pump and the documentation is a nightmare! They refer you to the MyLinkDrive tech notes for MXZ series, branch box system installs rather than making a video on it. Ridiculous. To top it off, the tech notes suck. I did consider placing the reservoir in the wall, to the right of the unit, that way you would just need to remove a wall cover, or cut a small hole in the drywall to access the reservoir for replacement.
@MrPhys
@MrPhys Жыл бұрын
The covers on these units are removable, but I suggest getting a hanging tool. I love my Mighty Bracket but, any brand is fine i'm sure.
@SixTreyPro4200
@SixTreyPro4200 Жыл бұрын
yes you need to pump down, disconnect refrigerant pipes and it snaps off from the bottom. If you dont have mighty brackets then your taking it down and replacing it that way
@MrSmee-vt7cy
@MrSmee-vt7cy 3 жыл бұрын
Can the pump be installed without the reservoir and still work when the water reaches the pump or do I have to install the reservoir with the pump and unit?
@MrPhys
@MrPhys Жыл бұрын
you're going to need the reservoir
@bluefunk81
@bluefunk81 5 жыл бұрын
Where you just just mounted that rtank is where the lip of the wall bracket goes.....
@yorickhunt3371
@yorickhunt3371 5 жыл бұрын
That's what happens when you get a sales rep (instead of someone who knows what they're doing and why) to describe the installation.
@jdewitt-pn9kr
@jdewitt-pn9kr 13 күн бұрын
Oh no, how will it ever fit
@PhInIaZ
@PhInIaZ 5 жыл бұрын
I have an MXZ system with a branch box. I have two different pdf application notes. One says to break RT12 or TH2 with the black (COM) wire from the pump and the other says to break RT12 or TH2 with the yellow wire from the pump. Do I use the yellow or black (COM) wire? If yellow is used, what do I do with the black and red wire? If black is used, what do I do with the yellow and red wires?
@Dan-hd3cs
@Dan-hd3cs 2 жыл бұрын
Did you eventually figure it out? I am attempting an install of this pump with an MXZ-SM42NAMHZ and branch box. The indoor units are all MSZ-FS09NA and MSZ-FS12NA models. The tech notes on MyLinkDrive suck pretty bad. They need to create a video to address this.
@donhenderson9093
@donhenderson9093 Жыл бұрын
@@Dan-hd3cs where did you find the MyLinkDrive
@Dan-hd3cs
@Dan-hd3cs Жыл бұрын
@@donhenderson9093 I think you can find the link on Mitsubishi Electrics website
@desertfox4273
@desertfox4273 4 жыл бұрын
Dude should've used some crimp connectors, that wiring looks shoddy AF
@cosmiccharlie420
@cosmiccharlie420 3 жыл бұрын
Commercial Electric tools says it all
@m1geo
@m1geo 4 жыл бұрын
I hope this guy doesn't actually fit ACs. The wiring is poor with lots of exposed copper, twisted connections, as well as reservoir where the wall bracket would go! 🙈
@blabberskitess
@blabberskitess 4 жыл бұрын
This vid was good. But show terminations up close while terminating and when plugging in.
@skidscatt9892
@skidscatt9892 Жыл бұрын
Video is terrible. Never be this easy in yhe field. And very poor setup to show installation of this pump.
@skidscatt9892
@skidscatt9892 Жыл бұрын
It gets worse every time I watch this. And the design is piss poor as far as the wiring. Nowhere near enough wire on these pumps. What a joke
@daveydave9884
@daveydave9884 9 ай бұрын
Joke
@jimnorbeck5232
@jimnorbeck5232 Жыл бұрын
Mini splits are useless. Impossible to work on many of them. Pumps are useless. Good old fashioned drain lines or p- traps are better.
Installing A Mini Split Condensation Pump
10:05
Abilityman’s HVAC Toolbelt
Рет қаралды 85 М.
REFCO GOBI Condensate Pump Installation
9:56
REFCO Manufacturing Ltd.
Рет қаралды 93 М.
Quando eu quero Sushi (sem desperdiçar) 🍣
00:26
Los Wagners
Рет қаралды 15 МЛН
UFC 310 : Рахмонов VS Мачадо Гэрри
05:00
Setanta Sports UFC
Рет қаралды 1,2 МЛН
Леон киллер и Оля Полякова 😹
00:42
Канал Смеха
Рет қаралды 4,7 МЛН
How to Install a Blue Diamond Condensate Pump on a P-Series Wall-Mount Unit
10:12
Mitsubishi Electric Trane US
Рет қаралды 41 М.
ETR Showcase Wagner Cadillac
3:18
Mitsubishi Electric Trane US
Рет қаралды 159
diy mini split condensate pump install @aspenpumpsgroup
7:07
Taddy Digest
Рет қаралды 88 М.
Construction of a MEGA sized Modern Home PT 62 | Beams Everywhere!
25:55
Perkins Builder Brothers
Рет қаралды 171 М.
10 Reasons Why A Mini Split Flare May Be Leaking Refrigerant!
18:15
AC Service Tech LLC
Рет қаралды 752 М.
Ductless Cleaning and Maintenance Start to Finish
23:15
HVAC School
Рет қаралды 277 М.
How to Evacuate an AC system, Full Vacuum Procedure
27:35
HVAC School
Рет қаралды 1,2 МЛН
Quando eu quero Sushi (sem desperdiçar) 🍣
00:26
Los Wagners
Рет қаралды 15 МЛН