- We appreciate your Support and Purchases! - Replacement 2.0t TSI/FSI DV www.shopdap.com/oem-diverter-valve-dv-2-0-t-06h145710d.html DV Mounting Bolts www.shopdap.com/n-105-464-04.html
@hungrychowhound116125 жыл бұрын
Never a routine job. There is always some one new (me) who gets a lot out of these vids. It did help having the extensions to see exactly what is going on. Didn't expect to find under the car - but the engineer probably got a good laugh out of it. Over all thanks for helping out with this information. Thanks.
@greenwc3 жыл бұрын
Super helpful. Just replaced the diverter valve on our B7 avant today and it fixed my P0299 code! Best tools for me were 1/4 inch ratchet, 1/4 inch 5mm hex bit socket, and 3” 1/4 inch extension. Every other tool was either too long or got in the way. Take your time and be patient and it’s an easy swap.
@uro003 Жыл бұрын
Thank you needed to know where diverter valve was on my 09 so i could install my bov 💕
@angw86744 жыл бұрын
Best video I could find online. It’s almost impossible to see. I had a revision “C” and replace with a “J”. Thanks
@abtcup3 жыл бұрын
Holy smokes. I just did this. I had a really hard time getting to the lower left bolt. Things are so much easier when you have a lift.
@gmans78596 жыл бұрын
Thanks Guy's... Just did a new valve plus the GFB DV+ Kit on our MK6 GTI. Connector Plug was a bit stubborn but we got it. Very pleased with our efforts.
@Keepin-it-wheel1016 жыл бұрын
I changed this valve this year. It was leaking small amount of oil It leaked for 4 years. Small amounts... Finally I was able to change it. Much clean back there now..
@gmans78596 жыл бұрын
Yes, that's why we just did my sons car. Discovered it was an older revision and kept finding the connector with oil on it....
@raptor99265 жыл бұрын
Daniel Medrano I just noticed on my MK5 k04 oil leak from this diverter valve spacer is this normal ?
@ChutneyGames4 жыл бұрын
@@raptor9926 Is there a gasket on the spacer?
@hagong95045 жыл бұрын
Ed Sheeran working on VW’s now?
@johnchambers12 Жыл бұрын
This video was very well presented and better than any repair manual!
@Ronaldo_Football-Cr7 Жыл бұрын
Excellent demonstration
@kenlandis3182 жыл бұрын
Just watched the vid. Excellent camera placement. Great vid except at the end just before you appear to say finished you will notice that the 5 mm allen tool is still on diverter fastener!
@arringtonmc4 жыл бұрын
Thanks! This along with humble mechanics vid on this part I feel super confident about doing this myself!
@AtownCangri2 жыл бұрын
Long time subscriber, first time watching this video. Great opening line 😂
@joshriles844 жыл бұрын
Really adds too the whole experience lol
@davidscott41404 жыл бұрын
Great and easy to follow video
@MrNetstar10205 ай бұрын
You should post one of these videos for 2020 VW Passat se installing the DV+. not too much info out there because the job requires access from underneath.
@touaregkc2 жыл бұрын
Excellent show, thanks a lot. I might consider doing it myself, that is, my friend lets me use his crane...
@Billcozaaa8 ай бұрын
Hey I have a 2014 1.8 T, trying to replace the valve from underneath with ramps. It’s so difficult to reach. Any recommendations?
@Thanas905 күн бұрын
guys , where is location for DV valve on 1.8tsi ? EA888 gen 2? same like 2.0 tsi or ?
@shaune6293 Жыл бұрын
On a 2008 audi TT 2.0 tfsi error code p2261 is this the correct part to start with first?
@MPDano6 жыл бұрын
How do you unclip the connector? I see how it clips on the new one but can't get the clip off the old one.
@philtrujillo54014 жыл бұрын
I have the same problem. How did you end up getting it off? I'm afraid to break it. @MPDano
@kkelv4 жыл бұрын
Phil Trujillo Same problem here
@blobberooni Жыл бұрын
@@kkelv I know it's been 3 years but you push back on the little tab while pulling the connector in the other direction. Try with your hand before using a screwdriver, more prone to breaking. Good luck lol
@joaovitorsouza7613 жыл бұрын
after replacing this sensor the check engine light is supposed to turn off on its own or something else needs to be done?
@TheAestheticEnthusiast Жыл бұрын
So it looks like there is some sort of plate over where the location is shown in this video. There is however an identical looking part up by the right hand side of the front grill that is attached a large air hose, attached to the plastic turbo Inlet pipe, any ideas what's happening here?
@kenmwanzia53316 жыл бұрын
informative article. thanks
@m6h245 жыл бұрын
Thanks!!! A million
@Bsidesthepoint Жыл бұрын
Thanks for the vid. I have a 2012 Jetta GLI/tsi 2.0t . I purchased the valve part number 06h145710d. Is this the right part? The harness seems different.
@AntrakRaps4 жыл бұрын
Thank you!
@mariorivera3335 жыл бұрын
where the crankshaft sensor passat 2.0 tsi 2009 is located behind mutilple or between the transmission and motor
@pussymonster67078 ай бұрын
Thank you for the video I’m going to attempt this myself
@One_Guy6 жыл бұрын
are you doing a performance build on this? would you consider using a Go fast bits DV+ on this? why or why not?
@Werewolfmage3 жыл бұрын
how do you do the DV valve on a gen 3 1.8t passat say the 2014 flavor?
@fartman102846 жыл бұрын
Good luck using that socket combo on the actual car
@anthonyrizzo81452 жыл бұрын
Wondering if this is the same part we need? We have a 2014 VW Jetta, Trouble code P0045 Turbocharger / Supercharger Boost control solenoid A Circuit/ Open Your time is greatly appreciated.
@bengtholmberg85902 жыл бұрын
Can I use this on my Alltrack 1.8 Tsi? Will it fit?
@dalewhitmore1434 жыл бұрын
Please tell me I can put a diverter valve on my TDI???
@UA10i122 жыл бұрын
is it same for tdi? I can't seem to find it
@ollyk222 жыл бұрын
Have you got a video showing all the vacuum hoses on an FSI too please?
@tuwhelzreally7412 жыл бұрын
Is this the same for a 2012 Audi A6 2.0t
@marka77455 жыл бұрын
Would this fix a low compression problem on cylinder 3 on the 2.0T FSI engine? If not, what are the obvious suspects? Valve issues, etc? What's the typical cost to have a valve job done on this engine? Thanks, Mark
@tonycarpaccio95504 жыл бұрын
450 at a dealer. That's why I'm here lol
@colemeehan74123 жыл бұрын
What about a 2017 where is it located Jetta tsi 1.8t
@gregoryschwarz27303 жыл бұрын
Can you access this through the fender?
@frederichartell73905 жыл бұрын
Is it the same location on a 2016 Tiguan SEL?
@_multiverse_5 жыл бұрын
It's up top on newer cars, it's one of the first things he said.
@jujujuice9357 Жыл бұрын
can i do the same thing on my mk6 gli
@زيري-ط4غ Жыл бұрын
Its can oil leak from this?
@szmichalek4 жыл бұрын
Błąd p2261 również od dv?
@angelalbertofernandezgarci56074 жыл бұрын
I need a Valve specer for this gen3 , when
@Gushers22764 жыл бұрын
" A Ridiculous amount of extensions" :D
@Rdearth182 жыл бұрын
Is a diverter valve also known as a turbocharger recirculation valve?
@Salmon_Rush_Die2 жыл бұрын
yes
@misery_follows Жыл бұрын
i can’t find the tucking thing for the life of me
@TekNeez6 жыл бұрын
What would be reason to upgrade a DV in a MkV?
@osvaldosanchez22485 жыл бұрын
geekphreak the old valve fails
@_multiverse_5 жыл бұрын
The old valves with a bellows type diverter rip and leak boost to atmosphere, they changed the design to a piston which is more robust than a rubber bellows.
@StinkygooberTM5 жыл бұрын
Would the location be the same on a 1.8L EA888 Gen 3?
@joedesimone61175 жыл бұрын
B7 Passat Dude lol I just almost dropped half my turbo charger just to install mine on a 2014 vw gli gen 3 2.0T
@StinkygooberTM5 жыл бұрын
Joe DeSimone I’m thinking of paying for the install but idk if it’s really worth it putting down 400 just to get it on. );
@rahuljmc5 жыл бұрын
Joe DeSimone I’ve a 2016 GLI. Is the install procedure and location the same like in this video ?
@AhwasNasir5 жыл бұрын
U forgot ur tool in their
@TruEGTI6 жыл бұрын
Not enough extensions.
@dougdrefus42746 жыл бұрын
You left your 5mm on the diverter vale.
@Deutscheautoparts6 жыл бұрын
We like it there!
@TheBeardedBoofhead3 жыл бұрын
@@Deutscheautoparts ready for next time! :D
@andersonbuging26 жыл бұрын
I've been trying to change it on my car, but I don't have the ability to lift the car up. Let me tell you how much of a pain in the ass it is to even lift it up.
@Ryanbell13614 жыл бұрын
Drive up ramps at Harbor Freight Tools. Probably $40 max. Just dont overshoot the ramp and youll be about a foot off the ground.