How to install a fan on a 2017-2022 KTM Husqvarna or GasGas 300 Two Stroke

How to install a fan on a 2017-2022 KTM Husqvarna or GasGas 300 Two Stroke

[@beerbelly6670]

What do you think about also doing the thermostat delete kit with the fan?

[@MotoSurgeon]

What temp range is the ecu starting/stopping the fan? Thanks for the video!

[@RTiPowersports]

Thanks man! I can't remember exactly but I think it's somewhere close to 200.

[@shanekujala]

Where do you get the relay that you plugged into the plug that was on the bike?

[@chris_moodie9]

Is this the same for the xc models? cant seem to find the fan plug and the xc only has one relay not three

[@steberg341993]

same problem here. Did you figure it out in the meantime? I was thinking dedicated connection to the battery might fix it?

[@chris_moodie9]

@@steberg341993 i bought the ktm fan with the readout on it. The cheaper fan without relies on the in bike thermostat and relay. xc models don't have either so the fan would always have to be on or off using a switch. the readout is honestly super nice especially for the injected two strokes since they take so long to warm up properly. worth the couple extra $$, you do need the battery harness for it though.

[@steberg341993]

@@chris_moodie9 thank you! I'll look into it a bit deeper now

[@emanuelkowalski431]

Hey thks for the video, I’m just having a hard time to take out the connector from the rubber boot should I just pull ?

[@lg8188]

How’d you go? Does it just pull out?

[@emanuelkowalski431]

@@lg8188 sorry for the late answer but yes it just pulls out