How to install a New door skin BMW 2002

[@Restorezone]

One more tip for those who bother to scroll down and give the video a like or write a comment ... I really appreciate it ... So the tip is, afterwards don't forget to hang your " Sound Deadening Pad " back once you are done. If you don't want the " WOoooong " when you close the door , you're welcome 🫡 😄 👍

[@de_Leuran]

insanely satisfying work! Love to see an old BMW restored the right way. There must be a big future for this channel!

[@Restorezone]

Thanks ! 🙂

[@EstebanValentin]

Good stuff as always buddy. The attention to detail is great, I bet this will help many DIYers.

[@kennydelobel]

Great quality vid as always, explained so even dummies like me can understand 😅

[@Restorezone]

Thanks! 😁

[@danarbuckle6640]

Very very nice work. I wish you would have shown if you adjusted the door gaps after you put the doors on.

[@Restorezone]

I find the easiest way is to screw the bolt in from the inside, and just tighten it until it just touches the door. And then tighten very lightly, so that you can move the door up and down with minimum force. Then close the door carefully" be careful not to hit the fender" once the door is closed and then look at the seams, open the door halfway and slide it up and down to the position you want and check again, a video about this will seem a bit boring, this is fitting work, and it is a lot of opening and closing until you get the desired result. good luck and be patient :)

[@danarbuckle6640]

@@Restorezone Thanks much for your reply. Keep up the good work. Subscribed.

[@EricsUnfinishedProjects]

Beautiful job and great instructions regarding the process. Thanks so much!

[@jonathan8349]

Well done on the door and great job on the video!

[@conceptalfa]

Great work, thanks for sharing!!!👍👍👍

[@MrMokkeli]

Love ur videos, hope I will some day repair my own 2002

[@Restorezone]

Thank you ! I hope the same for you 🙏🙌🙂 ...

[@EinserPatrick]

Very nice job! Love too see it! 😊

[@mrt7152]

Zoals altijd, mooi werk!

[@gwynn1104]

Great job, I have holes in my outside skins in both sides and wasn’t sure if this was a job I could do. I think it is though 🤘

[@Restorezone]

thanks , and I say good luck , for when you start ;) will be fine

[@philippehuget3435]

C'est vraiment du super boulot !

[@Restorezone]

Merci! 🙂

[@treymorriss2]

What happened to the project??

[@Restorezone]

Hello trey. i still have it sitting in a corner, but unfortunately i just don't have the time for it at the moment due to other projects like that e30 of my brother-in-law and other things that are holding up my own project , in hope when this one is out i can fly back into it In between my normal work ;) e30 project you can only follow at Instagram , grtz ✌️

[@carsandwhisky2002]

Nice work!!! I’ll be DIY restoring several of my 02s soon @carsandwhisky