How to Install Backrack Original Headache Rack Tonneau Cover Kit

[@chrismckinnon3603]

With this setup will Undercover factory installed trifold tonneau covers be able to flip up all the way including the tri-fold section closest to the back rack? Or will the tonneau cover only be able to flip the first two tri-fold

[@michaelsparks2582]

Are you required to remove your low profile cover before installation? Or can you install with it flipped up and out of the way?

[@swordsinging1709]

The base plate for this bracket system #40126 over laps and encroaches onto my Bak Revolver X4s Tonneau covers inside rail. I have a 2019 Chevy Colorado. Can I just skip using it and just bolt down the adapter bracket without it. That would fit. If not than it looks like I will be grinding 1/2" off the inside edge of the rail brackets. What say Ye? Backrack USA tech said it would fit and the instructions are no frills for sure.

[@Realtruck]

Hey there! The kit that BackRack uses for the BakFlip covers will hang off the side of the bed cap 1/2 inch. The only way to avoid that is to remove 1/2 inch from the inside edge, just like you mentioned. We have done that before, but we also cleaned up the cut edge and sealed it with a good paint.

[@nikosilvis4568]

What’s the torque spec?

[@WS6TA9T8]

whats the size of the nuts on the bed rail and the one on the carriage bolt?

[@Paul.atherton]

What bed cover

[@Darksteel165]

Looks like my Bak Flip MX4

[@Broncort1]

We’ll remove the protectors from our adhesive ducks…..