How to install flush mount speakers in ceiling dry wall

[@TampaTec]

Thank you for all your support, I enjoy helping my viewers and hope to continue to help for years to come. See how to hide speaker wires and connect Amp here- kzbin.info/www/bejne/bmnLXoiMerybe6c product list below- Pair of Polk Audio AW0080-B RC80i 2-way speakers- amzn.to/2FHxwdj Walabot DIY, Stud Finder- amzn.to/3mAO0oc Drywall Wallboard Saw- amzn.to/3iLkXMf Monoprice 18 Gauge AWG CL2 Rated 4 Conductor Speaker Wire Cable - amzn.to/33BUPNC -affiliate links with amzn.to earns myself revenue through amazon affiliate program.

[@_z4af]

Can u give me ur instagram because I need ur help

[@ucheikenyei5509]

Great job, curious to know the cost

[@johnparker9482]

Tampa Tec and Big Dog do outstanding work keep doing what you doing, it helped me out a whole lot thank you

[@kevinmartin8735]

I am going to do a couple of height speakers for a Dolby system and this video will be a big help. Thanks!

[@MOAB-UT]

Some AV's like the height in front, others in the rear- double check unless you already did it- how did it turn out?

[@kevinmartin8735]

@@MOAB-UT I am in a new build and the wiring for the heights were kinda mid room. I did the install (5.2.1 setup) and it sounds great!

[@MOAB-UT]

@@kevinmartin8735 That's great. At any time you can always add 2 more speakers. If you wire two 8 on speakers in parallel it drops down to 4 ohms. If you're not cranking it for hours you should be just fine that's what I did. Most receivers can handle a 4 ohm load. For your next upgrade get a 7. 1 with Atmos it will sound even more fantastic.

[@omar_padilla]

Nice job! But how about showing how to run a wire through a ceiling or wall because I'm sure a lot of people don't have attics.

[@TampaTec]

Yes, i made that video too, see the last 30 sec of this video that pop-up video link should be there. kzbin.info/www/bejne/bmnLXoiMerybe6c

[@microbeerreviews]

Very helpful, thank you for posting this video

[@jlindy73]

Curious how you located speakers left and right as compared to couch? Ultimately I know ceiling joist will be a constraint, but curious how close to a balance to seats

[@richardkanu407]

What a wonderful teacher nice job

[@yasserafiq]

Great video!! Is that OK for the ceiling insulation to sit on top of the speaker in the attic? Did you push it away from the speakers? Thanks

[@TampaTec]

I pushed it out but if some insulation lightly covers the speaker 🔊 it's ok.

[@turboflush]

I like to straighten out a coat hanger wire and send it into the attic instead of the screw. Easier to locate when your lost in the attic.

[@eshwar6969]

smart

[@PopDisplay1]

what is the grip capacity (max ceiling thickness)?

[@irfanahmed3662]

I would like to know how to connect speakers wire with amplifier????

[@Mowers11]

Great install. I will do this for my church Monday. What do you think of Rockville audio? I have the Rpa79wbt amp and 6.5” in ceiling speakers.

[@TampaTec]

@@Mowers11 I like Polk audio I installed them in many houses when I was a ht installer. amzn.to/4dE8HJv *Affiliate

[@electronic7979]

Excellent

[@thecross8250]

I have Prowl speakers to install how do I connect them to my receiver. They have a transformer and transmitter has got transformer feeders

[@lany_07gaming]

Nice info as always.👍

[@jacobh0]

Did you protect the back of the speakers from the blown insulation?

[@chevalier8076]

No need to.

[@joef5660]

I would make a box out of xps foam board and cover over the speaker. Keep that vapor barrier tight and prevent moisture leaving your house during the winter.

[@Mymatevince]

Nice neat job Paul :-)

[@MrMrSaldana]

I saw a bucket clear that the drywal and drill went through and it caught literally 90% of dust

[@jakebryant5829]

Question on these speakers and the spray in insulation. Will it cause a fire if the insulation is touching the back of these ceiling speakers? Also what is the recommended wiring for these speakers? Guage and or type of wire. Thanks!

[@Matt-tc9kp]

It’s low voltage. Not a lot of risk

[@eddiemunsey6585]

What kind of tube amp is that????

[@6strings4]

What if I have these installed and want to take them with me when I move how can I hide the holes

[@chevalier8076]

Lol you will have to re patch the holes. Not that difficult.

[@sergiolopez5652]

What siez of speakers 8 inch

[@BenSinz45s]

Good install man. Beat was good it went with the video footage 👍🏽

[@TampaTec]

Thanks 👍

[@Uwolz]

Paid for pre install from my builder and idiots put inlet covers with studs on some of them. I’m pissed as hell.

[@CimaVideoArts]

Hmmm speaker grill is the hardest part it seems, looks like it slightly too big and needs to bend too much

[@abdallahelectronic19]

Thank you ,شكرا لك with translation

[@Inspironator]

Tampatec, you need to double your attic insulation.

[@TampaTec]

Probably yeah.

[@houseofpainINKS]

Dude u dont answer your ig account or videos on here , might be cause they old videos but if u do answer id like to chat run by you what my tv is doing and see if u can have an answer i switched the power board and your people sent a bad one so they sent another and tv still shuts off let me know if u can help

[@TampaTec]

My people? I don't have tv repair shop but only do that as a hobby. I used to work as a tech years ago. I use shopjimmy.com and electropartsonline.com check them out.

[@NativeVsColonial]

My house is made of solid bricks and cement, lol

[@eddgutierrez5811]

Why is there a weed whacker in your attic

[@swarren925]

How come no one has an install in a basement that’s finished. Everyone is doing these vids in a ranch style house one the first floor and going in the attic

[@billykl2790]

You are using a keyhole saw

[@darronsanderson4837]

You always need a subwoofer. 🔊🔊

[@aMabbitt]

Someone saw linus do it

[@TampaTec]

Yep, I saw that video, it was good but as an installer I thought I could add few tips and tricks. I made another ceiling speaker install video about 7 years ago but this one is better.

[@hugob3585]

this is not flush mount.. this is regular in ceiling speakers

[@Baerchenization]

Ceiling speakers! For people who want the same listening experience they have at their local fast food joint ;)

[@TampaTec]

Polk audio 2 way speakers is a better experience than single cone speakers. Check them out.

[@Baerchenization]

@@TampaTec I would never swap a set of proper speakers for a ceiling solution. Even a sound bar would be much better.

[@chevalier8076]

Not really! A 5.1 you still need rears spkrs for that nice surround sound.

[@ocdtechtalk]

Polk Audio is the cheapest of the cheapest. Spend a little more and do the job one time.

[@AngelLuisTrinidad]

Good luck doing this on a concrete ceiling.