How To Install Oversynth.com Overlays on Moog Mother-32 & DFAM Synthesizers

This video shows how to install Oversynth overlays on the Moog Mother-32 and DFAM synthesizers. Overlays are available from www.oversynth.com
Instructions Overview:
- Loosen the patch bay nuts using a 5/16” (5/16 inch) socket or small wrench (available from most local hardware stores or from our web-store by clicking this link). There is no need to completely remove the nuts, just loosen them about a nut’s width from the front panel surface.
- Remove the front panel knobs. You may need to use a small knife or letter opener to pry the knobs off. We recommend wrapping the knife with masking tape to avoid scratching the front panel.
- Remove the 8 front panel screws using a Phillip’s head screwdriver.
- Place the overlay over the synthesizer’s front panel, making sure it lays flat. It should sit clear of or behind all front panel nuts.
- Re-intall all front panel screws, knobs, and nuts. The nuts only need to be snug using finger-strength. No need to over-tighten the nuts.