How to install racing stripes? 2015 - 2017 Ford Mustang | Wet application

[@scottbarbour9745]

Beautiful!

[@tankthebiker]

reviving the comment section...Did you just use no more tears J&J soap? That is awesome.

[@omarwilson491]

wow...nice

[@ycharlie5993]

Where did you get those sticky centerpiece yellow arrows?

[@usrallystripes]

we send them together with the order. They are really convenient for installation, that way you don't waste time lining up the stripes.

[@KvvianD]

what was the specific color?

[@jauharpm8040]

What are the dimensions of the stripes ?

[@cjperformance2023]

How long did it take for you to install the stripes

[@usrallystripes]

7 hours! Depending on the temperature and the skills, installation takes 6-9 hours. The drying time before removing the transfer is important.

[@abanoubarmanious9743]

@@usrallystripes How long should you wait? Also for the soap what should be the ratio of soap to water?

[@usrallystripes]

@@abanoubarmanious9743 between 30 min to an hour. There is no specific ratio for the amount of soap, for example, in a bottle of water, while I pour the soap I usually count to 3, that's the way I measure it.

[@linternasmx]

Use a cord to mark the center of the car. Easyest!

[@usrallystripes]

I don't think so, the "easiest" is not always the most convenient. Thanks anyway!

[@linternasmx]

@@usrallystripes Just place a nylon cord lined at front camera, next at light sensor in center of dashboard. Pull it to rear wihdshield an align to center of rear defroster lines (always is a square or a mark in center) or antenna, and finally to rear camera. Easy and precise. Regards.