How to install Resin Bound on steps and a footpath | step by step

[@georgemcmanus5943]

You can tell you guys do a really good job with how fussy yous are with the prep and cleaning at the end. Keep it up lads

[@tonydyke]

Appreciate that mate it’s all about the prep work! 🙌👍

[@Lee_Essex]

Very clean and tidy. Excellent job.

[@joshuamchale7726]

Great idea with the risers.

[@tonydyke]

Thanks Josh 👍

[@Jayjamie]

Top video boys! Lovely work. Started doing resin driveways 3 months ago, and I've really got Into it 👍

[@tonydyke]

Thanks mate 👍 it’s really enjoyable once you get into the swing of it!

[@Dontbesilly83]

Top work lads. The marigolds are a wicked idea. It can take weeks for the glue combined with the dust too get off of your skin. Lucky I’ve not of yet had any reactions.

[@khalidhassen5007]

Great video!! What ratio of Aggregate to resin do you usually do?

[@ployaerials1033]

Great video. I’ve got a 4sq metre area I plan to do soon. It’ll be sat on recently set concrete pad. Is there any sort of primer I need or will the correctly mixed resin set on it fine? Also, any idea what will happen to this stuff if I drill it? It’s basically going to be a patio which I want to install a pergola on!? Thanks

[@OurDisneyFloridaLife]

Cool 👍

[@shawnwhtmr]

Top job boys toom your time and did a lovley job

[@u2kjib4cjkqn]

I cast the risers in big strips cut them to length and trim to size to fit the individual steps ,your way looks good but you are using a lot more trims and the only issue I can see with the back the backing board is water getting behind and possibly freezing which could cause problems .

[@DrDisasta]

Would this work for the fascia of a home? I would like that.

[@ridasuknongsiej2734]

Where I can buy this rasin bound

[@HollywoodSmilesColombia]

How much you charge per ft2* ?

[@thomasneely2700]

Is this not resin bonded rather than resin bound?

[@dickydoodle]

Shouldn't the aggregate be washed before mixing with resin ? 2 extensions plugged into each other, not fully unwound is asking for a fire to start. Try mitering the corners on the metal perimeter trims as yours looks unprofessional.